HP D2D4009fc HP StoreOnce Conversion from 2.x.x software to 3.4.x (or later) S - Page 22
This command will return either of the following after a prepare command has been sent
View all HP D2D4009fc manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
1. Prepare storage. After the delete command has completed, build the storage system using the following StoreOnce CLI command to discover and add storage to the system: hardware prepare storage This command will return quickly once prerequisite checks are completed but the process of actually creating the LUNs may take several minutes to complete depending on the amount of storage being added. If successful, this command will return "Command Successful." The command will fail if: • A previous prepare storage command is already running • There is no storage to be added • There are insufficient expansion licenses applied to allow the entire expansion to complete (in this case no expansion will take place until sufficient licenses are present for all added storage) • There are any "foreign" LUNs already present on the attached storage • There are any failed or predictive fail disks in either the existing or newly added storage. • If the storage is connected to an incorrect RAID controller or is "daisy-chained" from the wrong expansion enclosure. 2. Monitor progress. After the command returns successfully it is possible to monitor the status of the LUN creation process using the following command: hardware show storage status (or its alias: system show status) This command will return either of the following after a prepare command has been sent: Discovering or Discovered XXTB 3. Add storage. Once the discovery process is complete, run the following command in order to format the storage LUN with file system segments: hardware add storage This command will then create and expand the filesystem to use all of the storage. The process can take a long time to complete and the new capacity will not be available until it is finished. HP StoreOnce 2610/2620 Backup system HP StoreOnce 4210/4220 and 4420/4430 Backup system Approximately 30 minutes Head only = approximately one hour nl Add approximately 20 minutes per expansion shelf The expansion can be monitored using the following command: hardware show storage status (or its alias: system show status) This command will return either of the following after an add command has been sent: Formatting or Formatted XXTB The hardware add storage command will fail if: • There is an outstanding prepare or add command in progress • Any of the error conditions described in the prepare storage command have not been rectified 22 Software Installation and configuration