HP AJ732A Cisco Nexus 5000 Series Release Notes Release 4.0(1a)N1(1a) (OL-1660 - Page 7
Fibre Channel Port Shutdown, Switched Port Analyzer (SPAN
UPC - 883585789481
View all HP AJ732A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Release 4.0(1a)N1(1a) Upgrade and Downgrade Issues Send documentation comments to [email protected] When an Ethernet interface joins a EtherChannel, the following interface level parameters are disabled: bandwidth delay duplex flowcontrol ip ipv6 mac priority-flow-control service-policy spanning-tree speed storm-control Set bandwidth informational parameter Specify interface throughput delay Enter the port duplex mode Configure interface flowcontrol Configure IP features Configure IPv6 features MAC configuration commands Configure interface priority-flowcontrol Configure QoS service policy Spanning Tree Subsystem Enter the port speed Configure Interface storm control Fibre Channel Port Shutdown The following table describes the changes to the interface shutdown command syntax. 4.0(0)-based releases 4.0(1a)N1(1a) Upgrade Downgrade The system default switchport shutdown command causes all Fibre Channel ports, virtual or physical, to default to shutdown. The system default switchport shutdown command now configures the administrative state for all Ethernet ports as down. To configure the Fibre Channel ports to shutdown state, use the system default switchport shutdown san command. Ethernet ports will default to shutdown instead of Fibre Channel ports. This capability needs to be reconfigured after the downgrade. Otherwise, the switch will flag the system default switchport shutdown san command as invalid. Switched Port Analyzer (SPAN) The following table describes the changes to SPAN sessions. 4.0(0)-based releases 4.0(1a)N1(1a) The default is to keep session in an open state. To shut a session, use the following command: switch(config)# monitor session session-number suspend The default is to keep session state shut. To open a session, use the following command: switch(config)# no monitor session session-number shut Upgrade Downgrade Note The syntax of the command has also changed. The suspend keyword has been changed to shut. SPAN session will be in shut state after the upgrade. If you do not execute a specific shut or no-shut command on the SPAN session, the SPAN session will be in a no suspend state after the downgrade. OL-16601-01 Cisco Nexus 5000 Series Release Notes, Release 4.0(1a)N1(1a) 7