Harman Kardon AVR 145 Owners Manual - Page 21

INSTALLATION STEPS NOTE: It isn't possible to make recordings using component video connections. Keep this in mind as you connect other source devices that you may wish to make recordings from. Video 2 Source The Video 2 source is used only for playback, never recording. The AVR 145 remote control is programmed to operate many brands and models of cable and satellite television devices, and we recommend connecting your cable or satellite set-top box to this source. Referring to Table 2, connect your set-top box to the Video 2 Analog Audio inputs and to the Optical 1 Digital Audio input. If possible, use the Component Video 2 inputs. Otherwise, connect the set-top box's S-video or composite video output to the matching Video 2 video input. DVD The DVD source is used for a DVD player. If you have a more advanced multichannel device, such as a Blu-ray Disc or HD-DVD player, connect it to the DVD source. Referring to Table 2, connect your DVD player to the DVD Analog Audio inputs and to the Coaxial 1 Digital Audio input. If possible, use the Component Video 1 inputs. Otherwise, connect the DVD player's S-video or composite video output to the matching DVD video input. Figure 21 - DVD A/V, DIgital Audio and Component Video Inputs If your DVD player plays multichannel lossless discs, such as SACD or DVD-Audio, you will also need to connect the 6-channel analog audio outputs on the DVD player to the 6-channel analog audio inputs on the receiver in order to enjoy these discs to their fullest. Figure 19 - Video 2 A/V, DIgital Audio and Component Video Inputs NOTE: If you receive your television programming using your TV with an antenna or direct cable connection, then you will need to connect the analog and optical digital audio (if available on your TV) outputs to the Video 2 Analog Audio inputs and to the Optical 1 Digital Audio input. Do not connect any video output on the television set to any video input on the receiver. See Step Five for information on connecting the receiver's video monitor outputs to the television. Video 3 Source The Video 3 source is used only for playback, never recording. It is also generally reserved for components that are only temporarily connected to the receiver, such as cameras and game consoles. When not in use, you may place the supplied covers over the front-panel Video 3 jacks for a cleaner appearance. Simply snap the covers in place. When you wish to use the jacks, gently press on the left side of each cover to pivot it out for removal. Referring to Table 2, connect your camera or game console to the Video 3 Analog Audio inputs and to either the Coaxial 3 or Optical 3 digital audio input. If possible, use the Component Video 2 inputs. Otherwise, connect the component's S-video or composite video output to the matching Video 3 video input. Figure 20 - Video 3 A/V and Digital Audio Inputs Figure 22 - 6-Channel Analog Audio Inputs CD The CD source is used for a strictly audio device, such as a CD player. Referring to Table 2, connect your CD player to the CD Analog Audio inputs and to the Coaxial 2 or Optical 2 Digital Audio input. Figure 23 - CD Audio Inputs and Digital Audio Inputs No video connections are made, although if your system has unusual requirements, you may connect a video device using component video outputs to the Component Video 2 inputs on the receiver, if those jacks are not in use by another device. Tape The Tape source is used for audio-only recorders, such as a CDR, MiniDisc or cassette deck. Referring to Table 2, connect your recorder to the Tape Analog Audio inputs and outputs, and to either the Coax 2 or Optical 2 Digital Audio input (and corresponding digital audio output). 21