Haier HPU-16CB03 User Manual - Page 26

Installation procedures Display of whole unit Try to bring the packed unit to the installation place. When it is inevitable to unpack the unit, be careful not to damage the unit. Wrap it with nylon etc. After unpacking, be sure to put it with the front side of the unit facing up. Note: When delivering, don't hold plastic Delivery Facing up parts like inlet and outlet grill etc. Installation of outdoor unit Selection of installation place Place strong enough to support the unit and will not cause vibration and noise. Place where discharged wind and noise doesn't cause a nuisance to the neighbors. Place where is less affected by rain or direct sunlight and is sufficiently ventilated, or to install a shield. Place with enough space for smooth air flow. Do not install the air conditioner on the non-special metal bracket (e.g. theft guarding net). If outdoor unit is street installed, it cannot be lower than 2.5m The air outlet of outdoor unit shall be no less than 3m away from the neighbors. If necessary, it shall get the neighbor's agreement. Fixing of the unit Use expansion bolt (M10) to fix the outdoor unit installation bracket on the wall. Use bolt (M10) and nut to fix the outdoor unit on the installation bracket and keep horizontal. Fix outdoor unit using M10 bolt to concrete floor horizontally. If installed on the wall or on top of a roof, bracket should be fixed securely to resist earthquake or storms. Use rubber pad during installation against unit vibration. 256 140 500 140 HPU-16CB03 HPU-23CB03 Installation dimension of outdoor unit (mm) 24