Haier FCD-8 User Manual - Page 4

Dimension Figure Front view a1 Cutaway view (F igFuirgeu1re) 1 Side view F b1 E D C AB d1 A B c1 A Hot water outlet M o d el Vol um e Net weight a1 b1 c1 d1 B Cold water inlet C Mg anode rod FCD-8 8L 5kg 325mm 414mm 100mm 255mm D Heating element E Enamel tank F Wall-mounting bracket Remarks:the permitted error limit of above parameters is ±10%. Schematic Diagram L:Brown wire N:Blue wire MT:High temperature limiter EH:Heating element E:Yellow/green wire BT: Thermostat L N E HL:Heating indicator MT BT EH HL E 3 PDF pdfFactory Pro www.fineprint.cn Installation Be sure to have it installed by the appointed staff. It adopts wall-mounting installation. First decide the installation location according to the usage requirement. Make two holes in the wall with depth 70mm and φ9mm by churn drill as per the indication of installation diagram. Fasten the wall-mounting plate on the wall tightly with two expansion bolts as per indicated in Figure 2. Check and confirm that the bolts are not loose. Hang the water heater vertically onto the wall by the wall-mounting plate. Confirm it is firmly mounted. Please reserve certain space for the future maintenance during ins tallatio n. (Figure 2) (Figure 3) 65mm Wall- mounti ng plat e Expansion bolt Connect to drain hose When the power is switched on, and the water heater starts operating, there may be some water discharged from the pressure relief hole of safety valve. It is due to the water expansion under heating, and is normal phenomenon. The pressure relief hole shall communicate with the air directly. Do not block it. If the water heater will be installed in the bathroom without sewer, we suggest you add drain hose. Fasten the drain hose to the drain thread of safety valve by twisting (see to Figure 3). According to the need, you could truncate or elongate the hose in your favor. Connect the other end of drain hose to the sewer to avoid polluting the room by splashing. The drain hose connecting to the safety valve shall be kept downward sloping in installation and in a frost-free environment. Be sure to check and confirm that the tank is filled with water, there is no leakage at each joint and the power supply complies with the stipulation before switching on the power. (Figure 4) for reference in installation only Hot water outlet Safety valve Cold water inlet 4