Haier ES6V-Q1 User Manual - Page 1

Haier ES6V-Q1 Manual

Page 1 highlights

Troubleshooting Symptom Things to Check Solutions 1 Whether the water supply has stopped or whether the Check water pressure is too low No water 2 Whether the water-usage point is blocked or whether the hot water valve is Check and clear openeded 1 Whether hot water outlet is opened Check and open Only cold 2 Whether the water water but temperature is adjusted the heating 3 Heating time is too short indicator lamp and set temperature is not is lit achieved Adjust water temperature Continue heating 4 Whetehr heating pipe is damaged Con rm it is not due to the reasons under then contact Maintenance Department 1 Whether power is properly Only cold connected water and the heating indicator lamp 2 Check whether there is power supply is not lit 3 Whether thermostat is out of control Check power socket Connect power switch Con rm it is not due to the reasons under① ②, then contact Maintenance Department Heating indicator light Is on all the time 1 Water has not reached the set temperature 2 Whether thermostat is out of control Continue heating Con rm it is not due to the reason under①, then contact Maintenance Department Water volume is sometimes large or small, or water is sometimes hot or cold Samll hot water out ow volume Whether water pressure is stable 1 Whether the present temperature setting is too low 2 Whether water pressure is too much Adjust water out owing volume or make sure water pressure is stable before using Re-adjust the temperature setting As far as possible reduce the water valve's out ow volume during use; for details please refer to the tips in Important Notices Haier Home Water Heater Instruction manual ES6V-Q1(H) 0040503073 V Please read this Instruction Manual carefully before use. Please retain this manual for future reference. Safety Notices (Please read before use) Meanings of Icons Prohibited Compulsory Matters Essential Matters Forbidden Warning Caution Immediately cut o power supply and Non-professionals are strictly prohibited contact our Service Center once the from carrying out repairs, maintenance, water heater does not work properly or Forbidden dismantling or revamping of the water emits burnt smell. heater. 230V/50Hz independent power source must be used at all times. Installation of water heater outdoors is strictly prohibited. Warning Forbidden To ensure safety, the water heater should be connected to independent Do not install the water heater in an sockets (do not use adapters), with environment which is susceptible to ice- Earthing reliable earthing. In addition the power socket must conform to national Forbidden formation. Ice will cause the container and water pipe to break, leading to standards. Use of water heater without scalding and water leakage. reliable earthing is strictly prohibited. Use pen multimeter to check whether the live line and zero line are reverse. Do not use damaged wire and power socket. Promptly clean the dust on the power plug and socket. Warning Check the power meter and the electric Please take precautionary measures during cold weather, in order to prevent damage to water heater from freezing. Warning If the soft power cable is damaged, it must be replaced by professional sta from the manufacturers or Maintenance Warning Department in order to avoid danger. wire's diameter to ensure that they Warning comply with the rated current for the water heater. Where necessary engage quali ed electrician to check the electric circuit. Do not touch the plug with wet hands, and make sure that the water heater, Caution Take care not to be scalded by heated water. • Touching of hot water valve and pipes is strictly prohibited. • Make sure to check the water temperature before use; use only when it feels suitable. plug socket do not come into contact Forbidden with water. If they are accidentally wet, they must be checked by professions Do not use water from the water heater for drinking or similar purposes. appointed by our company before Forbidden using, in order to prevent electrocution. Please cut o the power supply if Sotring of in ammable and explosive items near the water heater is strictly Forbidden prohibited. Do not connect to power when Caution the water heater was not used for an extended period of time. Drain the water heater of all water according to the instructions in the chapter on Cleaning and Maintenance. installing or repairing the water heater. Forbidden 1 Speci cations Introduction of exterior and accessories Rear view Side view Cross-section view b1 a1 Model No. Net weight (kg) Volume (L) a1 b1 c1 d1 e1 ES6V-Q1(H) 5 6 100mm 348mm 246mm 120mm 273mm A Hot water outlet B Cold water intake D Temperature measurement pipe E Inner chamber Note: The margin of error for the above parameters is ±10%. C Heating pipe F Anode rod Technical data Rated voltage/ Rated Rated Waterproof Rated power frequency temperature rating pressure Water pressure 230V~/2000W 50Hz 75°C IPX4 0.8MPa Not less than 0.05MPa Mixing factor 00% Average temperature of hot water outlet 00 °C Re-heating time(a Diameter of power temperature rise of 50°C ) wire 00min 00mm2 Packing list Quantity Name of parts Electric Water Safety Valve/Water Instruction Expandable Product Model No. Heater (unit) Drainage Pipe (set) Manual (copy) Hook (pcs) ES6V-Q1(H) 1 1 1 2 Electrical Diagram L: Live wire (brown) N: Zero line (blue) MT: Manual-reset thermostat BT: Constant-temperature thermostat EH: Heating pipe E: Earth line (yellow-green; dual color) HL: Heating indicator light 2

  • 1
  • 2

ES6V-Q1(H)
0040503073
V
Specifications
Introduction of exterior and accessories
Troubleshooting
Side view
Cross-section view
b1
a1
Rear view
Model No.
Net
weight
(kg)
Volume
(L)
a1
b1
c1
d1
e1
ES6V-Q1(H)
5
6
100mm 348mm 246mm 120mm 273mm
A
Hot water
outlet
B
Cold water intake
C
Heating pipe
D Temperature measurement pipe
E Inner chamber
F Anode rod
Note:
The margin of error for the above parameters is
±
10%.
Product Model No.
Electric Water
Heater (unit)
Safety Valve/Water
Drainage Pipe (set)
Instruction
Manual (copy)
Expandable
Hook (pcs)
ES6V-Q1(H)
1
1
1
2
Technical data
Packing list
Electrical Diagram
L:
Live wire (brown)
N:
Zero line (blue)
MT: Manual-reset thermostat
BT: Constant-temperature thermostat
EH: Heating pipe
E:
Earth line (yellow-green; dual color)
HL: Heating indicator light
Symptom
Things to Check
Solutions
No water
1
Whether the water supply
has stopped or whether the
water pressure is too low
Check
2
Whether the water-usage
point is blocked or whether
the hot water valve is
openeded
Check and clear
Only cold
water but
the heating
indicator lamp
is lit
1
Whether hot water outlet is
opened
Check and open
2
Whether the water
temperature is adjusted
Adjust water temperature
3
Heating time is too short
and set temperature is not
achieved
Continue heating
4
Whetehr heating pipe is
damaged
Confirm it is not due to the reasons under
, then contact Maintenance Department
Only cold
water and
the heating
indicator lamp
is not lit
1
Whether power is properly
connected
Check power socket
2
Check whether there is
power supply
Connect power switch
3
Whether thermostat is out
of control
Confirm it is not due to the reasons under
,
then contact Maintenance Department
Heating
indicator light
Is on all the
time
1
Water has not reached the
set temperature
Continue heating
2
Whether thermostat is out
of control
Confirm it is not due to the reason under
,
then contact Maintenance Department
Water volume
is sometimes
large or small,
or water is
sometimes
hot or cold
Whether water pressure is
stable
Adjust water outflowing volume or make sure
water pressure is stable before using
Samll hot
water outflow
volume
1
Whether the present
temperature setting is too
low
Re-adjust the temperature setting
2
Whether water pressure is
too much
As far as possible reduce the water valve's
outflow volume during use; for details please
refer to the tips in Important Notices
Haier Home Water Heater
Instruction manual
Safety Notices
(Please read before use)
Prohibited
Compulsory Matters
Essential Matters
Immediately cut off power supply and
contact our Service Center once the
water heater does not work properly or
emits burnt smell.
230V
/
50Hz independent power source
must be used at all times.
To ensure safety, the water heater
should be connected to independent
sockets (do not use adapters), with
reliable earthing. In addition the power
socket must conform to national
standards. Use of water heater without
reliable earthing is strictly prohibited.
Use pen multimeter to check whether
the live line and zero line are reverse.
Do not use damaged wire and power
socket. Promptly clean the dust on the
power plug and socket.
Check the power meter and the electric
wire's diameter to ensure that they
comply with the rated current for the
water heater. Where necessary engage
qualified electrician to check the
electric circuit.
Do not touch the plug with wet hands,
and make sure that the water heater,
plug socket do not come into contact
with water. If they are accidentally wet,
they must be checked by professions
appointed by our company before
using, in order to prevent electrocution.
Sotring of inflammable and explosive
items near the water heater is strictly
prohibited.
Do not connect to power when
installing or repairing the water heater.
Non-professionals are strictly prohibited
from carrying out repairs, maintenance,
dismantling or revamping of the water
heater.
Installation of water heater outdoors is
strictly prohibited.
Do not install the water heater in an
environment which is susceptible to ice-
formation. Ice will cause the container
and water pipe to break, leading to
scalding and water leakage.
Please take precautionary measures
during cold weather, in order to prevent
damage to water heater from freezing.
If the soft power cable is damaged, it
must be replaced by professional staff
from the manufacturers or Maintenance
Department in order to avoid danger.
Take care not to be scalded by heated
water.
Touching of hot water valve and
pipes is strictly prohibited.
Make sure to check the water
temperature before use; use only
when it feels suitable.
Do not use water from the water heater
for drinking or similar purposes.
Please cut off the power supply if
the water heater was not used for an
extended period of time. Drain the
water heater of all water according
to the instructions in the chapter on
Cleaning and Maintenance.
Please read this Instruction Manual carefully before use.
Please retain this manual for future reference.
Quantity
Name of parts
Earthing
Forbidden
Forbidden
Forbidden
Forbidden
Forbidden
Forbidden
Forbidden
Forbidden
Warning
Warning
Warning
Warning
Warning
Warning
Caution
Caution
Caution
Meanings of Icons
1
2
Rated voltage/
power
Rated
frequency
Rated
temperature
Waterproof
rating
Rated
pressure
Water pressure
230V~/2000W
50Hz
75°C
°C
IPX4
0.8MPa
Not less than 0.05MPa
Mixing factor
Average temperature
of hot water outlet
Re-heating time(a
temperature rise of 50
)
Diameter of power
wire
00%
00
00
min
00
mm
2
°C