Graco 840301 User Manual - Page 3

LATCH locations Newer vehicles have one or more seating positions with LATCH anchorage systems. If vehicle is equipped with LATCH, the vehicle lower anchor points may be visible at the vehicle seat crease. If not visible, they may be marked with the symbol below . Typical seat in a passenger vehicle. Other vehicle types may have See your vehicle owner's manual for exact different LATCH locations. locations, anchor identification, and requirements for use with an infant restraint. Vehicle Lower  Anchor Points Vehicle Seat Crease Using LATCH to Install Base  1. For ease of installation, extend LATCH to its maximum length. 2. Position base in vehicle seat as shown . 3. Thread LATCH through base belt path normally used for vehicle seat belt. Make sure that ‘ LATCH is UNDER tongue on base . Belt must lay flat and not be twisted. 4. Hook connectors to vehicle lower anchors. Pull firmly on connectors to make sure they ’ are attached ‘. 5. Tighten LATCH by pushing down hard on base and pulling the adjustment belt ’. 6. NEVER put two LATCH connectors on one vehicle LATCH anchor unless specifically allowed by the manufacturer “. “ Test infant restraint for secure installation as described in infant restraint "Final Safety Check" pg 2. Check that the LATCH stays tight and does not slip from the tightened position. If it does not stay tight, try another seating position or contact Customer Service. 3 Tongue