GE PDWT380RSS Installation Instructions - Page 13
Step 16 - Connect Water Supply, Step 17 - Connect Drain Line, Drain Line Installation
UPC - 084691194460
View all GE PDWT380RSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Dishwasher Installation STEP 16 - CONNECT WATER SUPPLY Connect water supply line to the 90° elbow. • Slide compression nut, then ferrule over end of water line. • Insert water line into 90° elbow. • Slide ferrule against elbow and secure with compression nut. IMPORTANT - Check to be sure that door spring does not rub or contact the fill hose or water supply line. Test by opening and closing the door. Reroute the lines if a rubbing noise or interference occurs. Compression Nut Ferrule NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED 10' FOR PROPER DRAIN OPERATION. DRAIN LINE INSTALLATION • Connect drain line to air gap, waste tee or disposer using the previously determined method. • Secure the drain hose to the air gap, waste tee or disposer with clamps. Method 1 - Air gap with waste tee or disposer Insert the drain hose into the air gap as shown. 90° Elbow Hot Water Supply Line Figure DD 90° Elbow Door Spring STEP 17 - CONNECT DRAIN LINE The molded end of the drain hose will fit 5/8" through 1" diameter inlet ports on the air gap, waste tee or disposer. • Determine size of inlet port • Cut drain hose connector on the marked line, if required, to fit the inlet port. Cutting Line IMPORTANT: Do not cut corrugated portion of hose 1" 5/8" Waste Tee Installation Figure GG Disposer Installation Method 2 - High Drain Loop with the Waste Tee or Disposer Route the drain hose of the dishwasher to a minimum height of 32" from the floor with the supplied hanger as shown. g g pp 32" 18" Min. Min. Waste Tee Installation Figure HH 32" 18" Min. Min. Disposer Installation Figure EE • If a longer drain hose is required, and you did not purchase 10' long GPF10L drain hose, add up to 3-1/2' of length for a total of 10' to the factory-installed hose. Use 5/8" or 7/8" inside diameter hose and a coupler to connect the two hose ends. Secure the connection with 2^d_[Ta 7^bT2[P\_ hose clamps. Figure FF 7^bT2[P\_ IMPORTANT - One of the above methods must be used or dishwasher will not operate properly. IMPORTANT - When connecting drain line to disposer, check to be sure that drain plug has been removed. DISHWASHER WILL NOT DRAIN IF PLUG IS LEFT IN PLACE. AT\^eT 7^__Ta ?[dV Tip: Avoid unnecessary service call charges. Always be sure disposer drain plug has been removed before attaching dishwasher drain hose to the disposer. 13