GE PDWF2 Installation Instructions - Page 6
Installation, Preparation, Water, Supply, CAUTION
View all GE PDWF2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Installation Preparation-Hot Water Supply PREPARE HOT WATER SUPPLY Hot Water Line • The line may enter from either side, rear, or floor within the shaded area shown in Figure F. • The line may pass through the same hole as the electrical cable and drain hose, or an additional 1-1/2" diameter hole may be cut to accommodate the water line. If a power cord with plug is used, the water line must not pass through the power cord hole. A CAUTION The hot water supply line pressure must be at least 20 PSI. Lower pressures could cause the water valve to leak and cause water damage. I • • 1-3/2" Dia Shut-off Hole Valve 4" g-4" ± 5" 2" 6" From Cabinet 9" From Wall Cabinet Face-.Figure F 2" From Floor Water Line Connection • Turn off the water supply. • Install a hand shut-off valve in an accessible location, such as under the sink. (Optional, but strongly recommended and may be required by local codes.) • The water connection is on the bottom left side of the dishwasher. Install the hot water inlet line, using 3/8" or larger copper tubing. Route the line as shown in Figure F and extend forward at least 19" from rear wall. • Adjust the water heater to deliver water between 120°F and 150°F. • Flush water line to clean out debris. Use a bucket to catch water and debris. • The hot water supply line pressure must be between 20 and 120 PSI. 6