GE JVX5300SJSS Use and Care Manual - Page 6
Controls, Chef Connect, USING THE HOOD
![]() |
View all GE JVX5300SJSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
USING THE HOOD: &RQWUROV&KHI&RQQHFW Controls On Some Models 3 4 21 5 1. Rangehood Control Panel: The glass touch control panel is located on the front of the canopy. 2. Light Pad: 2Q1LJKW2IIVZLWFKIRUWKHOLJKWV Press the LIGHT pad to turn the lights on, again to set the lights to night setting, and again to turn off. 3. Auto Off Pad: Off switch for the fan. The fan can be operated by pressing any of the fan setting pads. Hold for 3 seconds to activate auto off after 15 minutes. Chef Connect 4. Fan Settings Pads: Speed control for fan. Press the pad Lo for LOW speed, Med for MEDIUM speed and Hi for HIGH speed. Hold down the Hi button for 3 seconds to activate the BOOST SPEED that will run for 10 minutes. 5. Chef Connect: This is a Bluetooth® pairing feature for use with other compatible Chef Connect enabled products on a cooktop or a range. When the device is paired, the light and fan will turn ON at the Default Sync Settings upon receiving a command from the range or cooktop. It will remain ON at that setting until the user changes it. Chef Connect Operation Bluetooth® Connection To pair with another device: To start the pairing process on the hood, press and hold the Light pad for 3 seconds. The backlight for the Lo - Med - Hi - Light will flash in that sequence until the hood is paired with the range or other device. If the pairing is successful, all 4 lights (Lo, Med, Hi, and Light) will flash three times simultaneously and then turn off. It will time out after 2 minutes if pairing is not completed. After which the pairing sequence will need to be restarted. To cancel pairing: To cancel the pairing hold the Light pad for 3 seconds and then turn off the hood. Default Sync Settings: The factory default setting for the light will be the brightest. The factory default setting for the fan sync will be OFF. The user can change the Default Sync Settings by pressing and holding the Lo pad for 3 seconds. This will enter the Default Settings Mode. Once in this mode, the backlights for all buttons (Lo, Med, Hi, and Light) will EOLQN2Q2IILQGHILQLWHO\DQGWKHIDQDQGOLJKWZLOOVZLWFK to the current Default Sync Setting, so the user knows what the current default value is. At this time, set the light and fan to the desired default levels. Once the user is satisfied with the selection, press and hold the Off pad for 3 seconds. This will exit this mode. At that time the backlights will stop blinking and the state of the fan and light will change back to their prior state before entering the Default Settings Mode. 6 49-80783-3
![](/manual_guide/products/general-electric-pvx7360sjss-use-care-manual-ecb9904/6.png)