GE JK5500SFSS Installation Instructions - Page 7
Bottom Trim Installation, Mount The Oven
View all GE JK5500SFSS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
10 MOUNT THE OVEN WARNING: Mounting screws must be used. Failure to do so could result in the oven falling out of the cabinet, causing serious injury. NOTE: During oven mounting step, ensure that no damage is done to oven gasket which lines the edge of oven cavity. NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening as it will go and is centered. NOTE: If the cabinet is particle board, you must use #8 x ¾" particle board screws. These may be purchased at any hardware store. A. Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws provided. B. Secure the oven cabinet with the screws provided. Mounting Hole Locations (hole locations may vary) The Screws Must Be a Minimum of 1/4" (6 mm) From the Front of the Cutout. 11 BOTTOM TRIM INSTALLATION • With oven installed, attach the bottom trim through its mounting holes in front vertical brace using two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct. SWO's and DWO installations without pedestal DWO's with pedestals IMPORTANT: If this unit is ever removed from the cabinet or the oven is ever pulled out for service, the bottom trim must be removed first or damage to the trim will occur.