GE DCVH660EHMS Installation Instructions - Page 1
GE DCVH660EHMS - G.E. 7.0 Cu.Ft. Electric Dryer Manual
UPC - 084691167402
View all GE DCVH660EHMS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Installation Instructions Electric Dryer 54 Questions on Installation? Call: 1-800-GECARES (US) or Visit our Web site at: www.GEAppliances.com (US) BEFORE YOU BEGIN Read these instructions completely and carefully. • IMPORTANT - Save these instructions for local inspector's use. • IMPORTANT - Observe all governing codes and ordinances. • Note to Installer - Be sure to leave these instructions with the customer. • Note to Customer - Keep these instructions with your Use and Care Book for future reference. • This dryer must be exhausted to the outdoors. • Before the old dryer is removed from service or discarded, remove the dryer door. • Service information and the wiring diagram are located in the control console. • Do not allow children on or in the appliance. Close supervision of children is necessary when the appliance is used near children. FOR YOUR SAFETY: WARNING • Use only rigid metal or flexible metal 4-in. diameter ductwork for exhausting to the outdoors. Never use plastic or other combustible, easy-to-puncture ductwork. • This appliance must be properly grounded and installed as described in these instructions. • Do not install or store appliance in an area where it will be exposed to water and/or weather • Install the dryer where the temperature is above 50ºF for satisfactory operation of the dryer control system. NOTE: Installation and service of this dryer requires basic mechanical and electrical skills. It is your responsibility to contact a qualified installer to make the electrical connections. TOOLS YOU WILL NEED MATERIALS YOU WILL NEED SLIP JOINT PLIERS FLAT BLADE SCREWDRIVER PHILLIPS SCREWDRIVER LEVEL 4" DIA. METAL DUCT (RECOMMENDED) 4" DUCT CLAMPS (2) OR 4" SPRING CLAMPS (2) 4" DIA. METAL ELBOW EXHAUST HOOD SAFETY GLASSES 4" DIA. FLEXIBLE METAL DUCT (IF NEEDED) DUCT TAPE 3/4" STRAIN RELIEF GLOVES UL RECOGNIZED DRYER POWER CORD KIT (NOT PROVIDED WITH DRYER) UL RATED 120/240V, 30A WITH 3 OR 4 PRONGS. IDENTIFY THE PLUG TYPE AS PER THE HOUSE RECEPTACLE BEFORE PURCHASING LINE CORD. Step 1 Step 2 Step 3 Step 4 Step 5 Step 6 Step 7 Prepare the Area and Exhaust for Installation of New Dryer (see section 1). Check and Ensure the Existing External Exhaust is Clean (see section 1) and Meets Attached Installation Specifications (see section 3). Remove the Foam Shipping Pads (see section 1). Move the Dryer to the Desired Location. Connect the Power Supply (see section 2). Connect the External Exhaust (see section 4). Level Your Dryer (see section 5). Step 8 Step 9 Check the Operation of the Power Supply and Venting. Place the Owners Manual and the Installation Instructions in a Location Where They Will Be Noticed By the Owner. For Alcove or Closet Installation, see section 6. For Bathroom or Bedroom Installation, see section 7. For Mobile or Manufactured Home see, section 8. For side or bottom exhaust, see section 9.