GE CGU366SEHSS Quick Specs - Page 2

CGU366SEH GE Café™ Series 36" Gas Rangetop with 6 Burners (Natural Gas) Dimensions and Installation Information Side View with a Backsplash Backsplash Accessories The rangetop requires a 12" minimum clearance to a vertical combustible surface at the rear. A backsplash is required for installations with less than 12" clearance. The following backsplash accessories are available, or a custom, non-combustible backsplash can be used. ZX12B36PSS, 12" backsplash ZXADJB36PSS, 30"-36" adjustable-height backsplash with warming shelf Backsplash with Warming Shelf All Professional Hoods feature infrared warming lights. The 30"-36" adjustable backsplash with warming shelf is a perfect complement when installed with the tapered or straight-sided hoods. • Restaurant-Style Professional Hoods are shipped with a 22" stainless steel backsplash and warming shelf. Advance Planning for 36" Professional Rangetops Universal Utility Locations Professional rangetops offer a number of choices in size and rangetop configurations. • All Professional rangetops are factory set for natural or liquid propane gas. The correct model should be ordered for the installation situation. Note: Conversion kits are included with the rangetop if the wrong gas type was ordered. High Altitude kit, WB28K10553, is also available. The kits must be installed by a qualified service technician at additional cost. For answers to your Monogram® or GE® appliance questions, visit our website at ge.com or call GE Answer Center® service, 800.626.2000. Electrical Requirements Rangetops must be supplied with 120V, 60Hz, and connected to an individual, properly grounded branch circuit protected by a 15 amp circuit breaker or timedelay fuse. Gas Supply • Natural gas models are designed to operate at 5" water column pressure. For proper operation, the pressure of the natural gas supplied to the regulator must be between 7" and 13" water column. • The liquid propane models are designed to operate at 10" water column pressure. For proper operation, the pressure of the LP source to the regulator must be between 11" and 13" water column. Specification Revised 7/14