Ganz Security ZN-PTZ202XE Manual - Page 7

ZN-PTZ202XE Installation Guide 4. INSTALLATION Roll-up String hole 32-pin socket 1) Secure three screws inside a PCB board shield's three unit holders with metal rings attached in the end. 2) Connect all necessary cables to a PCB board before attaching the shield to an installation surface. 3) Under the PCB board shield has a 32pin connector which matches the main camera body's 32-pin socket; The shield's three unit holders also align with the main camera body's three unit holder holes. 4) Once cable connect is complete along with brackets and poles on an installation spot, hook the roll-up string that is attached to a board shield to the main body. Main body has a secured string holder hole. 5) Align the connector and socket, and then push the main body to conjoin. 6) Once two units are attached, rotate the main camera body counterclockwise to secure the lock. ! To prevent products from damaging, place the camera on stable and non-vibrat ing surfaces. If the stability is in doubt, consult with safety personnel for reinfor Caution cements, and then proceed with the installation. 01A.00 7