Ganz Security ZN-NH11VNE Quick User Guide - Page 1

ZN-Y11VP(N)E/ZN-NH11VP(N)E/ZN-NHW11VP(N)E Quick User Guide This manual has been designed to guide you through basic settings of your IP devices, such as installation and configuration for using them. Step1. Connect cables to IP device Connect each cable to the device. To see the correct positions of all connectors, refer to the following image below. * Models herein and their appearance are subject to change LOOP OUT without any prior notice. RESET Button RESET RS-485 DO DI AUDIO - + C 1 C 1 Out In Micro SD ‐ + + ‐ RED ETHERNET LAN CCCCWW CCWW SeStETSScCRrEeW w (For IRIS LENS) DC 12V Power Adaptor Connector (DC 12V) ! Caution Make sure the polarity is correct. Incorrect connection may cause malfunction or damage to the IP device. Step2. Set up network environment The default IP address of your IP device is 192.168.XXX.XXX. You can find the available IP address from the MAC address of your device. Please make sure the device and your PC are on the same network segment before running the installation. If the network segment was different between your PC and the device, change your PC's settings as below. IP address : 192.168.xxx.xxx Subnet mask: 255.255.0.0 EC11 Ver1.2 1