Ganz Security ZM-L35T Manual - Page 4
Functions & Operation, Video Level, AC/DC Voltage
 |
View all Ganz Security ZM-L35T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Functions & Operation Type A - Measurement 1. Video Level a. Power On device and push "MODE" key to go to the "VIDEO" page. b. Connect "Video Out" of device with "Video In" (yellow BNC connector) on video extension cord to measure the video level. c. System will auto-detect NTSC/ PAL video signal and the measured voltage value will be shown as below: 2. AC/DC Voltage a. Switch "MODE" key to "AC150V~250V", "AC20V~150V" or "DC" page. b. Connect two ends of termination with probe to measure voltage. Caution: While in DC measurement mode, it is important to distinguish between the positive and negative (+/-) leads. c. The measured voltage will be indicated on screen as shown below:
-
1 -
2 -
3 -
4 -
5 -
6 -
7 -
8 -
9 -
10 -
11
 |
 |
Functions & Operation
Type A - Measurement
1. Video Level
a. Power On device and push “MODE” key to go to the “VIDEO” page.
b. Connect “Video Out” of device with “Video In” (yellow BNC connector)
on video extension cord to measure the video level.
c. System will auto-detect NTSC/ PAL video signal and the measured
voltage value will be shown as below:
2. AC/DC Voltage
a. Switch “MODE” key to “AC150V~250V”, “AC20V~150V” or “DC”
page.
b. Connect two ends of termination with probe to measure voltage.
Caution: While in DC measurement mode, it is important to
distinguish between the positive and negative
(+/-)
leads.
c. The measured voltage will be indicated on screen as shown below: