Frigidaire FPCC3685KS Complete Owner's Guide (English) - Page 6

BEFORE SETTING SURFACE CONTROLS About the Ceramic Glass Cooktop The ceramic cooktop has inductors and radiant surface elements located below the surface of the glass. The design of the ceramic cooktop outlines the area of the surface element underneath. Make sure the diameter of the pan matches the diameter of the element outline on the cooktop (See Figs. 1 to 4). Only flat-bottom cookware should be used. The type and size of cookware, the number of surface elements in use and their settings are all factors that will affect the amount of heat that will spread to areas beyond the surface elements. The areas surrounding the elements may become hot enough to cause burns. Figure 1 - 30" Model  NOTE Please read detailed instructions for ceramic glass cooktop cleaning in the General Care & Cleaning section and Before You Call checklist section of this Use and Care Guide. About the Radiant Surface Elements The element temperature rises gradually and evenly. As the temperature rises, the element will glow red. To maintain the selected setting, the element will cycle ON and OFF. The heating element retains enough heat to provide a uniform and consistent heat during the OFF cycle. For efficient cooking, turn OFF the element several minutes before cooking is complete. This will allow residual heat to complete the cooking process. The surface elements are located on the 36" cooktop as follows (Figure 2): • Two 7 inch radiant elements are located at the left front and rear positions. • One mid-position radiant element located between left front and rear element. Connects with front element to form Bridge element. • One 6 inch radiant element located at the center rear position. • One 6 inch induction element located at the right rear position. • One 10 inch induction element located at the right front position. Locations of the Surface Radiant & Induction Elements Your cooktop is equipped with radiant surface radiant elements with different wattage ratings. The ability to heat food quicker and in larger volumes increases as the element wattage increases. The surface elements are located on the 30" cooktop as follows (Figure 1): • Two 7 inch radiant elements are located at the left front and rear positions. • One mid-position radiant element located between left front and rear element. Connects with front element to form Bridge element. • One 6 inch induction element located at the right rear position. • One 10 inch induction element located at the right front position. Figure 2 - 36" Model 6