Frigidaire FHPC082AC1 Complete Owners Guide - Page 11

Remote Control 1 2 3 4 5 Operating Instructions 10 9 8 7 6 Fan Speed button On/off button Dry mode button Cool mode button Auto mode button Temp/Timer setting button Fan mode button Sleep button 9 Timer button 10 Change °F/°C button Battery Installation and Important Instructions When using the remote for the first time, pull out the plastic film on the back of the remote control. To replace the battery (when it has been used up), unscrew the screw at the back of the remote control then slide the cover off (Fig. 17). Insert the new battery. Install the cover back into place. If the remote control unit is replaced or discarded, the batteries must be pull out removed and disposed of in accordance with local legislation as they may harm the environment. Do not dispose of batteries in fire. Batteries may explode or leak. If the remote control is not used for a long time, remove the batteries from the remote control. The remote control must be handled with extreme care. Do not drop it or expose it to direct sunlight or sources of heat. WARNING: Chemical Burn Hazard. Keep batteries away from children. Fig.17 This product contains a lithium button/coin cell battery. If a new or used lithium button/coin cell battery is swallowed or enters the body, it can cause severe internal burns and can lead to death in as little as 2 hours. Always completely secure the battery compartment. If the battery compartment does not close securely, stop using the product, remove the batteries, and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention. The cells shall be disposed of properly, including keeping them away from children; Even used cells may cause injury. Point the remote control at the location of the signal receiver. The remote control must be no more than 16 ft(5 meters) away from the unit (without obstacles between the remote control and the unit). User Portable AC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Remote Control Fig.18