Frigidaire FHPC082AB1 Complete Owners Guide - Page 15
Fault Code
View all Frigidaire FHPC082AB1 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Operating Instructions function Press the " " and " "button the same time for more than 3 seconds to switch between degree Fahrenheit and degrees Celsius. Note: Under Dry/Fan mode, you can not select °F/°C. Timer mode How to delay startup Plug in the unit, so the unit turns to standby. Press the "timer" button, when the unit is off. The screen will display "timer" and "h", and the "on" will flashing. Tap or hold the UP arrow " " or the DOWN arrow " " to change delay start timer at 0.5 hour increments up to 10 hours, then at 1 hour increments up to 24 hours. After 3 seconds, the timer function is enabled, then "on" will stop flashing, the display will show the temperature back and the control will count down the time remaining until startup. The unit will start up in the mode as previously set. To cancel the setting, press the "timer" button again. You can also cancel the setting by pressingthe "on·off" button. How to delay shutdown You can delay shutdown when the unit is on. Press the "timer" button, when the unit is on. The screen will display "timer"and "h", and the "off " will flashing. Tap or hold the UP arrow " " or the DOWN arrow " " to change delay shutdown timer at 0.5 hour increments up to 10 hours, then at 1 hour increments up to 24 hours. After 3 seconds, the timer function is enabled, then "off " will stop flashing, the display will show the temperature back and the control will count down the time remaining until shutdown. To cancel the setting, press the "timer" button again. You can also cancel the setting by pressingthe "on·off" button. Fault Code If the screen on the unit displays "AS", the room temperature sensor has failed. Contact your Authorize Frigidaire Service Center. If the screen on the unit displays "ES", the pipe temperature sensor has failed. Contact your Authorize Frigidaire Service Center. If the display reads "E4" , the communication between display PCB and main control PCB is faulty. Contact your Authorized Frigidaire Service Center. If the screen on the unit displays "P1", the water collection tank inside the unit should be full. Refer to the "Drainage Instructions" on Page 16-17 for more instructions to drain the successive condensate. If error repeats, contact your Authorize Frigidaire Service Center.