Frigidaire FFPA1222T1 Complete Owner s Guide - Page 7

Installation Instructions Installation Instructions(continued) Installation in a double-hung sash window 1.Cut the foam seals A(adhesive type) to the proper lengths and attach them to the window and stool.(Fig.8) 2.Open the window sash and place the window slider kit on the window stool (Fig.9). Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the width of window. Screw down the two screws on the window slider kit. See Fig.9. Cut the adjustable window slider kit if the width of window is less than 26.6 inches(Fig.10). 3.Close the window sash securely against the window slider kit.(Fig.11) 4.Drive two 1 / 2″ screws to secure the window slider kit to the window sash.(Fig.11) 5.Secure the window slider kit to the window stool(Fig.11): A: For wooden window: Use 3 / 4″ screws for securing. B: For Vinyl-Clad windows: Use 1 / 2″ hex head cap screws for securing. 6.To secure lower sash in place, attach right angle sash lock with 1 / 2″ (12.7mm) screw as shown(Fig.12). NOTE: It is difficult to lock the windows with the sash lock for Vinyl-Clad windows, so you can use lock by window itself. 7.Cut the foam seal B to an appropriate length and seal the open gap between the top window sash and outer window sash, as shown in Fig.13. screws Window slider kit screws or hex head cap screws Window stool Fig.11 Foam seal B Fig.12 Fig.13 Installation in a sliding sash window 1.Cut the foam seals A(adhesive type) to the proper lengths and attach them to the window frame. See Fig.14. 2.Open the window sash and place the window slider kit on the window stool (Fig.15). Attach the window slider kit to the window stool. Adjust the length of the window slider kit according to the height of window. Screw down the two screws on the window slider kit. See Fig.15. Cut the adjustable window slider kit if the height of window is less than 26.6 inches(Fig.10). 3.Close the window sash securely against the window slider kit.(Fig.16) 4.Drive two 1 / 2″ screws to secure the window slider kit to the window sash.(Fig.16) 5.Drive two 3 / 4″ screws to secure the window slider kit to the window stool.(Fig.16) 6.Cut the foam seal B to an appropriate length and seal the open gap between the sliding sash and outer window sash, as shown in Fig.17. 7.To secure sliding sash in place, attach right angle sash lock with 1 / 2″ (12.7mm) screw as shown(Fig.18). screws Foam seal A (adhesive type) Fig.8 Window slider kit Window stool Fig.9 Cut this to fit your window Fig.10 Foam seal A (adhesive type) Window stool Fig.14 Window slider kit screws Fig.15 Window stool Window slider kit screws screws Fig.16 Foam seal B Fig.17 Fig.18