Frigidaire FFGW2415QS Installation Instructions - Page 5

GAS WALL OVEN INSTALLATION INSTRUCTIONS To adjust oven height: 1. Lay oven on its back (see Figure 6). 2. Remove the 3 screws that fasten the side ex- tension panel to the bottom sides of the oven. 3. Move each panel down to the position that increases the oven height to fit your opening. Each position changes oven height approximately ½". 4. Line up the appropriate holes in the side extension panels and sides of the oven. Put the 3 screws back. 5. Proceed with oven installation. Return to upright position. Oven Door 5. Cabinet Installation Insert appliance into cutout. Use the 2 mounting screws provided to fasten the front frame of the appliance to the cabinet (steps 1 below). Keep the 6 decorative screws to fix the decorative trim to the cabinet (step 2 below). The mounting holes in the front frame of appliance may be used as a template to locate the appliance mounting screw holes on the cabinet. To fasten the appliance to the cabinet (see Figure 7): 1. Use 2 mounting screws supplied to secure the appliance to the cabinetry. 2 holes are located under the center vent trim on each side. 2. Install the decorative trim panel to appliance bottom using the 6 supplied screws. Four screws are installed along the front of the panel. Two screw are installed at the opper corners of the panel. Center Vent Trim Mounting Screws Oven Bottom Figure 6 Extension Panel Decorative Screws Decorative Trim Decorative Screws Figure 7 5