Frigidaire FFGW2415QB Complete Owner s Guide - Page 17

Before you call Avoid Service Checklist Before you call for service, review this list. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this appliance. This oven is equipped with an electronic oven controller (some models). Among its many features is a full time oven circuit diagnostics system. The controller constantly monitors its internal circuitry as well as several crucial oven circuits, to insure they are all operating correctly. If at any time one of these systems fail, the controller will immediately shut down operation, and will beep and flash an error code of -F1-, -F3- or -F9- in the display window. OCCURRENCE POSSIBLE CAUSE/SOLUTION Oven Control Beeps and Displays Electronic control has detected a fault condition. Press STOP/CLEAR to clear any F code error ( example: -F1- the display and stop the beeping. Reprogram the oven. If a fault reoccurs, -F3- or -F9-). record the fault number. Press STOP/CLEAR and call Service center or another qualified servicer. Installation - Oven is not level. Place oven rack in center of oven. Place a level on the oven rack. Contact installing agent if rack and cabinet cutout flooring are not level. Kitchen cabinet misalignment may make oven appear to be not level. Be sure cabinets are square and level. Contact cabinet maker to correct problem. Entire appliance does not operate. Make sure cord / plug is securely plugged into electrical outlet. Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your dealer, installing agent or authorized servicer. Service wiring not complete. Contact your dealer, installing agent or authorized servicer. Power outage. Check house lights to be sure. Contact your local electric company. Short in cord/plug. Replace cord/plug. Controls are not set properly. See instructions to set the controls. House fuse has blown or circuit breaker has tripped immediately following installation. House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely. House fuse has blown or circuit breaker has tripped after the oven has been installed and previously operating. Call an authorized servicer. Wall oven is not properly connected to gas supply. Check connection (see installation instructions). Make sure gas supply shut-off valve is opened before turning on the oven after installing the wall oven. Oven light does not work. Burned-out or loose bulb. Follow instructions under Changing Oven Light to replace or tighten the bulb. 17