Foxconn nT-330i User manual - Page 31

Internet Connection

Get Foxconn nT-330i PDF manuals and user guides View all Foxconn nT-330i manuals
Add to My Manuals
Save this manual to your list of manuals

Page 31 highlights

5 5-3 Internet Connection 1. Wired Network Connection Setup The wired network is enabled by default. When you login system and connect a RJ-45 LAN cable, system will connect the wired network automatically. There will be a network connectable icon in the top right corner of your screen. If the network is unconnected, you can setup it easily by the following steps: 1.1. Make sure to open your router and connect the RJ-45 LAN cable. 1.2. Right-click the network icon, and select "Enable Networking". Then the network is established. 1.3. If the network icon still show "Disconnected", you may click on the network icon and select the "System eth0" to refresh it. ! If you want to disconnect the network, just to remove the selection of "Enable NetWorking" in step 2. 2. Create a new wired network 2.1. Right-click the network icon, choose "Edit Connections". 25 CAUTION

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
25
5
5-3 Internet Connection
1. Wired Network Connection Setup
The wired network is enabled by default. When you login system and connect a RJ-45 LAN cable,
system will connect the wired network automatically. There will be a network connectable icon in
the top right corner of your screen.
If the network is unconnected, you can setup it easily by the following steps:
1.1. Make sure to open your router and connect the RJ-45 LAN cable.
1.2. Right-click the network icon, and select “Enable Networking”.
Then the network is
established.
1.3. If the network icon still show “Disconnected”, you may click on the network icon and select
the “System eth0” to refresh it.
2. Create a new wired network
2.1. Right-click the network icon, choose “Edit Connections”.
If you want to disconnect the network, just to remove the selection of “Enable NetWorking”
in step 2.
CAUTION
!