Foxconn A7GM-S English Manual. - Page 40

3 cert to access memory. For a description of ganged (128-bit DRAM data width) and unganged (64-bit DRAM data width) DRAM modes : Ganged channels (DDR2) : ■ DCT channels A and B can be ganged as a single logical 128-bit DIMM. ■ Offers highest DDR2 bandwidth. ■ Requires both DIMMs in a logical pair to have identical size and timing parameters, both DCTs programmed identically. Unganged channels ■ DCT channels A and B operate as two completely independent 64-bit channels (both chan- nels operate at the same frequency). ■ Reduce DRAM page conflicts - more concurrent open dram pages . ■ Better bus efficiency. Burst lengths supported When both DCTs are enabled in unganged mode, BIOS must initialize the frequency of each DCT in order. ► Power Down Enable When power down mode is enabled, if all pages of the DRAMs associated with a CKE pin are closed, then these parts are placed in power down mode. ► Power Down Mode For non-mobile systems, power down mode should be set to [Channel] CKE control. A DIMM or a group of DIMMs enters power down mode by deasserting the corresponding clock enable signal when the DRAM controller detects that there are no transactions scheduled to any of the DIMMs connected to the clock enable signal. A DIMM or a group of DIMMs exits power down mode by asserting the corresponding clock enable signal when a transaction is scheduled to any DIMM connected to the clock enable signal. There are two CKE pins per DRAM channel. For each channel : [Channel] CKE control. The DRAM channel is placed in power down when all chip selects associated with the channel are idle. [Chip Select] CKE control. A chip select or pair of chip selects is placed in power down when no transactions are pending for the chip select(s). 33