Foxconn A7DA-S 3.0 English Manual. - Page 22
Front Panel Connector : FP1, Serial ATA Connectors : SATA1_SATA2, SATA3, SATA4, SATA5_ESATA, IrDA
View all Foxconn A7DA-S 3.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
2 Front Panel Connector : FP1 This motherboard includes one connector for connecting the front panel switch and LED Indicators. Hard Disk LED Connector (HDD-LED) Connect to the chassis front panel IDE indicator LED. It indicates the active status of the hard disks. This 2-pin connector is directional with +/- sign. Reset Switch (RESET-SW) Attach the connector to the Reset switch on the front panel of the case; the system will restart when the switch is pressed. Power LED Connector (PWR-LED) Connect to the power LED indicator on the front panel of the chassis. The Power LED indicates the system's status. When the system is in operation (S0 status), the LED is on. When the system gets into sleep mode (S1) , the LED is blinking; When the system is in S3/S4 sleep state or power off mode (S5), the LED is off. This 2-pin connector is directional with +/- sign. Power Switch Connector (PWR-SW) Connect to the power button on the front panel of the chassis. Push this switch allows the system to be turned on and off rather than using the power supply button. 12 + + HDD-LED - PWR-LED - RESET-SW PWR-SW NC EMPTY 9 10 FP1 Serial ATA Connectors : SATA1_SATA2, SATA3_ ESATA SATA4, SATA5_ESATA The Serial ATA connector is used to connect with SATA Hard Disk or CD devices which supporting this feature. The current 1 GND TX+ Serial ATA II interface allows up to 300MB/s data transfer TX- GND rate. RX- Note: There will be an ESATA cable in the package, you can RX+ GND use it to connect an ESATA hard disk to the upper SATA port SATA1_SATA2/SATA3_SATA4/ of SATA5_ESATA on the motherboard(as depicted). SATA5_ESATA IrDA Connector : IR This connector supports infrared wireless trans-mitting and receiving device. 1 2 3 4 5 IR +5V EMPTY IRRX GND IRTX 15