Foxconn A7DA 3.0 English Manual. - Page 107
Setting Up a Non-Bootable RAID Array
View all Foxconn A7DA 3.0 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
5 5-5 Setting Up a Non-Bootable RAID Array This section assumes the following setup : ■ Boot Disk with Windows XP installed : One hard disk HDS728090PLAT20 (80GB) is connected to the IDE channel, and set to Master. ■ A Mirrored RAID Array Disk : Two SATA hard disks are configured as a mirrored RAID1 array, they are : Hitachi HDT725025VLA3, (250.05GB) connected to SATA port2 of the motherboard. Seagate ST3320620AS, (320.07GB) connected to SATA port3. ■ A SATA DVD Drive : A DVD drive connected to SATA port1. WARNING! To achieve the best performance and reliability, we highly recommend you using the hard disks with the same brand, size and model number. Though we are using different brand of hard disks as an example here, the purpose is only for easy understanding. 1. Reboot your system, and go to "IDE Configuration" menu. Enable the RAID function. Press [F10] to save the settings and reboot. CMOS Setup Utility - Copyright (C) 1985-2008, American Megatrends, Inc. IDE Configuration IDE Configuration Help Item OnBoard PCI IDE Controller [Enabled] Native IDE OnChip SATA Channel [Enabled] I RAID OnChip SATA Type [RAID] AHCI SATA IDE Combined Mode [Enabled] Legacy IDE Move Enter:Select +/-/:Value F10:Save ESC:Exit F1:General Help F9:Optimized Defaults 100