Fellowes P-35C Manual 2 - Page 3

Basic Product Maintenance, Basic Shredding Operation, Troubleshooting, Limited Product Warranty

Page 3 highlights

BASIC SHREDDING OPERATION PAPER/CARD Continuous operation: 2-minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 2-minutes will trigger 20-minute cool down period. 1 2 Plug in and put disconnect power switch in ON (-) position Press Auto-On (I) 3 Check paper amount 4 5 or Feed paper straight into paper entry and release Feed into center of entry and release 6 When finished shredding set to OFF (O) BASIC PRODUCT MAINTENANCE OILING SHREDDER All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 3 Set to Off (0) *Apply oil across entry Set to Reverse (R) for 2-3 seconds *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 TROUBLESHOOTING PAPER JAM 1 2 3 4 Set to Reverse (R) for 2-3 seconds Set to Off (O) and unplug Gently pull uncut paper from paper entry. Plug in. Set to Reverse (R) LIMITED PRODUCT WARRANTY Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of incurred by Fellowes to provide parts or services outside of the country where the shredder is initially defects in material and workmanship and provides service and support for 1 year from the date of sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE from defects in material and workmanship for 3 years from the date of purchase by the original WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential consumer. If any part is found to be defective during the warranty period, your sole and exclusive or incidental damages attributable to this product. This warranty gives you specific legal rights. remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This The duration, terms, and conditions of this warranty are valid worldwide, except where different warranty does not apply in cases of abuse, mishandling, failure to comply with product usage limitations, restrictions, or conditions may be required by local law. For more details or to obtain standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer. unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs

  • 1
  • 2
  • 3
  • 4

Feed paper straight into
paper entry and release
or
Feed into center of
entry and release
When finished
shredding set
to OFF (O)
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
BASIC PRODUCT MAINTENANCE
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
OILING SHREDDER
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
*Apply oil across entry
Gently pull uncut
paper from paper
entry. Plug in.
Set to Off (0)
Press Auto-On (I)
PAPER/CARD
BASIC SHREDDING OPERATION
1
Check paper amount
Plug in and put
disconnect power
switch in ON (–) position
Continuous operation:
2-minute maximum
NOTE:
Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
2-minutes will trigger
20-minute cool down period.
Set to Reverse (R)
for 2-3 seconds
Set to Reverse (R)
for 2-3 seconds
PAPER JAM
Set to Reverse (R)
Set to Off (O)
and unplug
TROUBLESHOOTING
2
5
6
4
3
1
2
3
4
1
3
2
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. (“Fellowes”) warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 1 year from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 3 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes’ option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.