Fellowes 90S Manual - Page 2

F. A. B. G. C. KEY ENGLISH Model 90S D. A. Paper entry G. Control Panel and LEDs 6. Auto (blue) B. See safety instructions 1. Overheat (red) 7. Reverse C. CD/Card safety flap 2. Bin open (red) 8. ON/OFF (blue) D. Pullout bin 3. Bin full (red) 9. Forward E. Casters 4. Remove Paper (red) F. Disconnect power switch 5. Sheet capacity indicator 1. OFF 2. ON E. CAPABILITIES Will shred: Paper, credit cards, CD/DVD's, staples and small paper clips Will not shred: Adhesive labels, continous form paper, transparencies, newspaper, cardboard, large paper clips, laminates, file folders, X-rays or plastic other than noted above Paper shred size: Strip-Cut...5.8mm Maximum: Sheets per pass...18* CDs/Cards per pass...1* Paper entry width 230mm *A4 (70g), paper at 220-240V/50 Hz, 1.5Amps; heavier paper, humidity or other than rated voltage may reduce capacity. Recommended daily usage rates: 1,500 sheets per day, 50 credit cards; 10 CDs. 18 sheets per pass. IMPORTANT SAFETY INSTRUCTIONS - Read Before Using! • Keep away from children and pets. Keep hands away from paper entry. Always set to off or unplug when not in use. • Keep foreign objects - gloves, jewelry, clothing, hair, etc. - away from shredder openings. If object enters top opening, switch to Reverse ( ) to back out object. • Never use aerosol products, petroleum based lubricants or other flammable products on or near shredder. Do not use canned air on shredder. • Do not use if damaged or defective. Do not disassemble shredder. Do not place near or over heat source or water. • Operation, maintenance, and service requirements are covered in the instruction manual. Read the entire instruction manual before operating shredders. • This shredder has a Disconnect Power Switch (F) that must be in the ON (I) position to operate shredder. In case of emergency, move switch to OFF (O) position. This action will stop shredder immediately. • Avoid touching exposed cutting blades under shredder head. • Shredder must be plugged into a properly grounded wall outlet or socket of the voltage and amperage designated on the label. The grounded outlet or socket must be installed near the equipment and easily accessible. Energy converters, transformers, or extension cords should not be used with this product. • FIRE HAZARD - Do NOT shred greeting cards with sound chips or batteries. • For indoor use only. • Unplug shredder before cleaning or servicing. BASIC SET UP CASTER INSTALLATION 1 2 18 AUTO 3 4 18 AUTO 5 18 AUTO 2