Fellowes 60Cs Manual - Page 3

BASIC SHREDDING OPERATION PAPER/CARD Continuous operation: Up to 6 minute maximum NOTE: Shredder runs briefly after each pass to clear entry. Continuous operation beyond 6-minutes will trigger 30-minute cool down period. 1 2 3 4 Plug in and put disconnect power switch in ON (-) position Set to Auto-On ( ) Feed paper/card straight into paper entry and release When finished shredding set to OFF ( ) ADVANCED PRODUCT FEATURES SAFESENSE® TECHNOLOGY Stops shredding immediately when hands touch the paper opening. SET-UP AND TESTING 1 2 3 Set to Auto-On ( ) to activate SafeSense® Touch test area and look for the SafeSense® indicator to illuminate SafeSense® is active and working properly BASIC PRODUCT MAINTENANCE OILING SHREDDER All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. To avoid these problems, we recommend you oil your shredder each time you empty your waste bin. FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE 1 2 3 Set to OFF ( ) *Apply oil across entry Set to Reverse ( ) for 2-3 seconds *Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250 TROUBLESHOOTING 15 Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder. SafeSense® Indicator: If hands are too close to the paper entry, the SafeSense® indicator will illuminate and the shredder will stop shredding. PAPER JAM 1 2 3 Set to Reverse ( ) Alternate slowly back and forth 4 5 6 Set to OFF ( ) and unplug Gently pull uncut paper Set to Auto-On ( ) from paper entry. Plug in. and resume shredding