Fellowes 485Ci Manual 3 - Page 4

ENGLISH Models 425Ci/425i/485Ci/485i ADVANCED PRODUCT FEATURES SAFESENSE® TECHNOLOGY OPERATION Automatically stops when hands touch the paper opening. SET-UP AND TESTING 1 2 C-485Ci 3 AUTO C-485Ci AUTO SLEEP MODE OPERATION Energy saving feature shuts down the shredder after 2 minutes of inactivity WHEN IN SLEEP MODE 1 C -4 8 5 C i 2 3 C-485Ci AUTO AUTO Turn the shredder on to activate SafeSense® Touch test area and look for the SafeSense® indicator to illuminate SafeSense® is active and working properly In sleep mode To get out of sleep mode or insert paper touch control panel PRODUCT MAINTENANCE CLEANING AUTO-START INFRARED SENSORS Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the sensors may become blocked by paper dust causing the motor to run even if there is no paper present. (Note: two paper detection sensors are located in the center of the paper entry.) TO CLEAN THE SENSORS 1 2 C-485C C-485C 3 4 5 C-485C AUTO Turn off and unplug shredder Lift CD flap Locate Auto-start infrared sensor Dip cotton swab in rubbing alcohol AUTO OILTM Automatically oils the cutters to enhance performance and extend shredder life. (Auto oil system is only included on cross-cut models - 425Ci and 485Ci) REFILLING THE OIL 1 2 C-485C 3 C -4 8 5 C i AUTO Using cotton swab, wipe away any contamination from the paper sensors AUTO Low oil indicator will signal when your reservoir needs refilling To maintain shredder performance, refill oil reservoir with up to 12 oz. (355 ml.) of shredder oil (Fellowes 35250) Once refilled, automatic oiling will resume • All cross-cut shredders require oil for peak performance. If not oiled, a machine may experience diminished sheet capacity, intrusive noise when shredding and could ultimately stop running. We recommend that you refill the Auto OilTM reservoir as instructed for optimum performance. • If shipping shredder, oil must be drained. Open cabinet door and remove basket to access oil drain plug. Place suitable container under drain, remove plug and let oil drain out. Replace plug.