Epson XP-4100 Start Here - Installation Guide - Page 2

2 Gently shake the black ink cartridge. Note: Do not shake the other ink cartridges. 3 Unpack the ink cartridges. 4 Remove only the yellow tape from each ink cartridge. 9 Follow the on-screen instructions to adjust the print quality of your product. Note: • You need to load paper before you can adjust the print quality. See "Load paper" below for details. • Select Adjust Later if you want to adjust the print quality later. For more information, see the online User's Guide. 4 Load paper See the online User's Guide for information about loading capacity, available paper types and sizes, and loading envelopes. 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. Caution: Do not remove any other labels or seals, or ink will leak. Do not touch the green chip on the cartridge. 5 Insert the cartridge in the holder for each color. Press each cartridge down until it clicks. Make sure all cartridges are pushed down into place. 2 Slide the edge guides all the way out. 3 Load paper, glossy or printable side up and short edge first, in the middle of the rear paper feed slot. 6 Lift the scanner unit up slightly and lower it. When the scanner unit catches, lift it up again and lower it completely. 4 Slide the edge guides against the paper, but not too tightly. 7 Press OK to start charging the ink delivery system. 8 The printer starts charging the ink. Ink charging takes approximately 6 minutes. When you see a completion message on the printer's LCD screen, charging is complete. Caution: Don't turn off the printer or raise the scanner unit while it is charging or you'll waste ink. Note: As part of setup, your product's serial number will be sent to a secure Epson server so that you can be eligible to participate in programs we may offer from time to time, including the Epson ink replenishment program. You will have a separate opportunity to consent to participating in such programs. 5 Pull out the output tray. 6 Follow the instructions on the LCD screen to select your paper settings.