Epson WorkForce ST-C8000 Start Here - Installation Guide - Page 2

3 Insert the ink bottle into the filling port. Note: Do not force the bottles into position; they are keyed for each color. 4 Wait for the bottle to empty. Do not squeeze the bottle. 10 Raise the control panel, then press the power button to turn on the product. Note: If ink does not flow from the bottle, lift and reinsert the bottle. 5 When the ink bottle is empty, remove the ink bottle and replace the bottle cap. Note: Do not leave the ink bottle inserted; otherwise the bottle may be damaged or ink may leak. 6 Close the black ink tank cap. Note: If an error message appears, turn off the product and check that no protective material has been left inside the product and that the transportation lock is in the printing position. 11 Select your language, country, date, and time. Note: You can change these settings later using the product's control panel. For more information, see the online User's Guide. Follow steps 12 and 13 to continue ink charging. 12 When the message to see the Start Here sheet appears on the LCD screen, press and hold OK for 5 seconds. 13 When the ink confirmation message appears on the LCD screen, select Done to start charging the ink. Ink charging takes approximately 9 minutes. A message appears when ink charging is complete. Press OK to proceed with initial setup. Note: Part of the ink from the included bottles is used for printer setup. You will notice ink levels in the tanks decrease during charging. This decrease is normal and does not affect the stated in-box yields. Caution: Do not unplug or turn off the product, raise the scanner unit, or load paper while the product is charging or you'll waste ink. 7 Repeat the previous steps for the other colors. 8 Close the ink tank cover. 9 Connect the power cord to the back of the product and to an electrical outlet. 14 If there is ink remaining, repeat steps 1 through 8 to finish filling the ink tanks. If any ink remains in the bottles, close the bottles and store them for later use. Note: Replace the bottle cap before disposing of the bottles. 15 Select Settings > Maintenance > Ink Level Setting and follow the on-screen instructions to reset the ink levels. 3 Load paper See the online User's Guide for information about loading capacity, available paper types and sizes, loading envelopes, and using the rear paper feed slot or ADF. 1 Make sure the product is not charging ink, then pull out a paper cassette. Caution: Do not connect to your computer yet. 2 Slide the side edge guides all the way out.