Epson TM-U220 UB-R04 Technical Reference Guide - Page 24
Connect the UB-R04 to the TM Printer
View all Epson TM-U220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Connect the UB-R04 to the TM Printer 1 Confirm items in the pack. ("Unpacking" on page 19) 2 Remove the two screws of the universal interface connector of the TM Printer and connect the UB-R04, and fix it with two screws. 3 Set the DIP switch of the TM Printer. The interface of the TM printer must be selected as "parallel" with the appropriate settings. If a TM printer that can set the reset signal for pin 31 is used, set to "enable."When using the printer which supports both the USB vendor-defined class and the USB printer class, select the USB vendor-defined class. Refer to the Technical Reference Guide for each TM printer for these settings for details. Also, set the memory switches according to your needs. 4 Power on the printer. Then, after waiting a little, hold down the push button on the interface card for more than 3 seconds. The printer prints the status sheet for the UBR04. You can check all setting values necessary for the network connection. Push button 5 Turn the power switch of the TM Printer on while pressing the Feed button. The printer prints current status of the printer on the paper. 6 Turn off the TM Printer. 24