Epson TM-U220 UB-E04 Users Manual - Page 7
How to Set Up the Product
View all Epson TM-U220 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
How to Set Up the Product Preparation Printing a Status Sheet Power on the printer. Then, hold down the push button for more than 3 seconds to print a status sheet. You can check setting values necessary (IP address, Subnet mask, Gateway address) for the network connection. Connection Set the setting of the host PC to match the network setting that you have confirmed with the status sheet. You can check whether the connection to the printer has been correctly done by inputting the ping command. Example: ping 192.168.192.168 Note: Although the example shows the address 192.168.192.168, use whatever IP address is reported on the status sheet. Because the default IP addresses for all the printers are the same, you should power on and configure only one printer at a time. Resetting the product to Factory Defaults Hold down the push button on the interface card while turning on printer power and continue to hold it down until a message that initialization starts is printed. This causes all internal settings to return to their factory defaults. Setup There are two ways for the setup. For details, see the UB-E04 Technical Reference Guide. ❏ Using a Web browser 1. Input the IP address of this product in the address bar of the browser and press Enter. (Example: http://192.168.192.168 [default]). 2. In the User authentication screen, enter "epson" for both [user] and [password]. (default) *[user] is fixed to "epson" but you may change [password]. 3. Set parameters in each menu. If a parameter is changed, press [Send] to send settings to the printer. 4. In the screen displayed after sending settings, press [Reset] to enable settings. When changing the IP address, etc., make sure settings in the host PC match that of the printer. ❏ Using the EpsonNet Config (Ver. 4.5.7 or later) The EpsonNet Config is a utility to make network settings on an Epson printer with an Ethernet interface or a wireless LAN interface. You can download the Technical Reference Guide and the EpsonNet Config from one of the following URLs. For customers in North America: http://www.epson.com/support/ For customers in other countries: http://download.epson-biz.com/?service=pos 3