Epson TM-T88IV UB-E03 Users Manual - Page 3

How to Set Up the UB-E03 Preparation Printing a Status Sheet Power on the printer. Then, hold down the push button on the interface card for more than 3 seconds. The printer prints the parameters for the UB-E03. You can check all setting values necessary (IP address, Subnet mask, Gateway address) for the network connection. Connection Set the setting of the host PC to match the network setting that you have confirmed with the status sheet. You can check whether the connection to the printer has been correctly done by inputting the ping command through the command prompt. Example: Ping 192.168.192.168 Note: Although the example shows the address 192.168.192.168, use whatever IP address is reported on the status sheet. Because the default IP addresses for all the printers are the same, you should power on and configure only one printer at a time. Resetting the UB-E03 to Factory Defaults Hold down the push button on the interface card while turning on printer power and continue to hold it down until a message that initialization starts is printed (approximately for 10 seconds). This causes all internal settings to return to their factory defaults. Setup There are two ways for the setup. For details, see the UB-E03 Technical Reference Guide. ❏ Using a Web browser 1. Start Windows Internet Explorer (or your Web browser.) 2. Input the IP address of the UB-E03 in the browser address bar and press Enter (Example: http://192.168.192.168 [default]). 3. The browser displays an opening screen. 4. You can modify the parameters by following the menus. You must click Submit to send the change to the printer and then click Reset to make the submission effective on each Web page. If you change the IP address, etc., you have to change the setting of the host PC to match the printer's setting. ❏ Using the TMNet Win Config The TMNet Win Config is utility for Windows to make network settings on a TM printer with an Ethernet interface and a wireless LAN interface. 3