Epson SureColor S70670 Production Edition Alignment Guide - Page 20

Using the Paper Tape

Get Epson SureColor S70670 Production Edition PDF manuals and user guides View all Epson SureColor S70670 Production Edition manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

20 | Using the Paper Tape Using the Paper Tape Use the paper tape to attach media to the auto take-up reel core. This allows the media to "self-center," preventing skew and head strike issues. You can use the paper tape included with the printer or any paper tape that resists tearing and stretching. Note: Epson recommends using a roll core that is wider than the media you are printing on. This may help keep the edges of the media on the core as it is rolled up. 1. After media is loaded in the printer, do the following: • Grasp the center of the media edge and pull it straight down. • Pull the media down until the leading edge reaches the upper label on the after heater. 2. Cut off about 24 inches (60 cm) of paper tape and attach it to the media using adhesive tape. 3. Trim the corners of the media, leaving a straight section at the center about 4 to 8 inches (10 to 20 cm) wide. 4-8 in. (10-20 cm)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
20
|
Using the Paper Tape
Using the Paper Tape
Use the paper tape to attach media to the auto take-up reel core. This allows the media to “self-center,”
preventing skew and head strike issues. You can use the paper tape included with the printer or any paper
tape that resists tearing and stretching.
Note:
Epson recommends using a roll core that is wider than the media you are printing on. This may help keep
the edges of the media on the core as it is rolled up.
1.
After media is loaded in the printer, do the following:
•
Grasp the center of the media edge and pull it straight down.
•
Pull the media down until the leading edge reaches the upper label on the after heater.
2.
Cut off about 24 inches (60 cm) of paper tape and attach it to the media using adhesive tape.
3.
Trim the corners of the media, leaving a straight section at the center about 4 to 8 inches (10 to 20
cm) wide.
4-8 in. (10-20 cm)