Epson SureColor S70670 High Production Edition Product Update - Page 1
Epson SureColor S70670 High Production Edition Manual
View all Epson SureColor S70670 High Production Edition manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Epson® SureColor® S-Series English Product Update Your printer includes two accessories designed to prevent head strikes and paper misalignment when you use the auto take-up reel: • Tensioner media guides • Paper tape (non-adhesive), which ensures accurate media winding and saves media 2. Cut off about 24 inches (60 cm) of paper tape and attach it to the media using adhesive tape. 3. Trim the corners of the media, leaving a straight section at the center about 4 to 8 inches (10 to 20 cm) wide. Using the Tensioner Media Guides After media is loaded in the printer and auto take-up reel, place the tensioner media guides on the tension bar. They should lightly touch the edges of the media, without pressure. 4-8 in. (10-20 cm) 4. Feed the media by pressing the button, until the leading edge of the paper tape reaches the roll core on the auto take-up reel. 5. Attach the paper tape to the roll core using adhesive tape. If you want to take up media with the printed side facing in, attach the paper tape to the back of the roll core. Note: when the tensioner media guides are not in use, slide them to the edges of the tension bar. Using the Paper Tape Use the paper tape to attach media to the auto take-up reel core. This allows the media to "self-center," preventing skew and head strike issues. You can use the paper tape included with the printer or any paper tape that resists tearing and stretching. Note: Epson recommends using a roll core that is wider than the media you are printing on. This may help keep the edges of the media on the core as it is rolled up. 1. After media is loaded in the printer, do the following: • Grasp the center of the media edge and pull it straight down. • Pull the media down until the leading edge reaches the upper label on the after heater. 6. Set the Auto switch on the auto take-up reel according to the way you want to wind the paper: • Printed side out: • Printed side in: 7. Gently lower the tension bar. Make sure the paper tape does not come off. 8. Position the tensioner media guides after the media reaches the tension bar.