Epson ET-2650 Start Here - Installation Guide - Page 2

5 Fill the tank using all of the ink in the bottle. 11 Raise the control panel and turn on the product, then follow steps 12, 13, and 14 to continue ink charging. Note: Refer to the color coded sticker on the ink tank to identify the color of each tank. Caution: Be sure to fill each tank with the correct ink color. 6 Carefully seal the bottle using the reverse side of the bottle tip or screw on the lid for proper disposal. 7 Replace the ink tank cap securely. Note: If an error message appears, turn off the product and check that no protective material has been left inside the product. Caution: Do not lower the control panel without first squeezing the release bar underneath or you may damage the product. 12 To select English as your language, press the OK button. If you want to change the language, press or to select it, then press the OK button. Note: You can change the language later using the product's control panel. For more information, see the online User's Guide. 13 Press and hold the OK button for 3 seconds when the message to see the setup manual is displayed on the LCD screen. 8 Repeat the previous steps for the remaining bottles. 3 seconds 14 Press the button to start charging the ink. Ink charging takes approximately 20 minutes. Ink charging is complete when the power light stops flashing. 9 Close the ink tank cover. 10 Connect the power cord to the back of the product and to an electrical outlet. 20 minutes Note: The ink bottles included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product or load paper while the product is charging or you'll waste ink. 3 Load paper 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. Caution: Do not connect to your computer yet.