Epson ET-2600 Start Here - Installation Guide - Page 2
Load paper - ink
View all Epson ET-2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
5 Fill the tank using all of the ink in the bottle. 11 Raise the control panel and turn on the product. Wait for the power light to stop flashing, then follow step 12 to continue ink charging. Note: Refer to the color coded sticker on the ink tank to identify the color of each tank. Caution: Be sure to fill each tank with the correct ink color. 6 Carefully seal the bottle using the reverse side of the bottle tip or screw on the lid for proper disposal. 7 Replace the ink tank cap securely. 8 Repeat the previous steps for the remaining bottles. 9 Close the ink tank cover. Note: If all the product lights are flashing, turn off the product and check that no protective material has been left inside the product. Caution: Do not lower the control panel without first squeezing the release bar underneath or you may damage the product. 12 Press and hold the button for 3 seconds until the power light starts flashing, to begin charging the ink. Ink charging takes approximately 20 minutes. Ink charging is complete when the power light stops flashing. 3 seconds 20 minutes Note: The ink bottles included with the printer are designed for printer setup and not for resale. After some ink is used for charging, the rest is available for printing. Caution: Do not turn off the product or load paper while the product is charging or you'll waste ink. 3 Load paper 1 Make sure the product is not charging. Then flip the feeder guard forward, raise the paper support, and tilt it backwards slightly. 10 Connect the power cord to the back of the product and to an electrical outlet. 2 Slide the edge guide to the left. Caution: Do not connect to your computer yet.