Epson ET-15000 Start Here - Installation Guide - Page 2

5 Wait for the ink to fill the tank. Do not squeeze the bottle. Note: Ink flows into the tank and stops automatically when the ink is filled to the upper line. If ink does not flow from the bottle, lift and reinsert the bottle. Caution: After setup, periodically inspect the ink level to ensure it is not below the lowest line on the tank. Prolonged use when ink is below the lowest line could damage the product. See the online User's Guide for refilling instructions. 6 When the ink tank is full, remove the ink bottle and securely close it with the cap. Place the remaining ink aside; you will need it later. Note: Do not leave the ink bottle inserted; otherwise the bottle may be damaged or ink may leak. 7 Close the ink tank cap. 12 Raise the control panel, then press the power button to turn on the product. Note: If an error message appears, turn off the product and check that no protective material has been left inside the product. 13 Select your language, country, date, and time. Note: You can change these settings later using the product's control panel. For more information, see the online User's Guide. Follow steps 14 and 15 to continue ink charging. 14 When the message to see the Start Here sheet appears on the LCD screen, press and hold the help button for 5 seconds. 15 When the ink confirmation message appears on the LCD screen, select Done to start charging the ink. Ink charging takes approximately 10 minutes. Caution: Do not unplug or turn off the product, raise the scanner unit, or load paper while the product is charging or you'll waste ink. 8 Repeat the previous steps for the other colors. 9 Close the ink tank cover. 10 Lift the scanner unit up slightly and lower it. When the scanner unit catches, lift it up again and lower it completely. 11 Connect the power cord to the back of the product and to an electrical outlet. Note: The included ink bottles are designed for reliable printer setup and cannot be resold. After setup, the remaining ink is available for printing. 16 To complete filling the ink tanks, repeat steps 1 through 7 using the remaining ink in the bottles. Note: Replace the bottle cap before disposing of the bottles. 17 Close the ink tank cover and scanner unit. 18 Select Next and follow the on-screen instructions to reset the ink levels. 19 Follow the on-screen instructions to adjust the print quality. Note: • You need to load paper before you can adjust the print quality. See "Load paper" on the back of this sheet for details. • You can change these settings later using the product's control panel. For more information, see the online User's Guide. Caution: Do not connect to your computer yet.