Epson AP-60 Installation Guide - Page 9

Introduction Before installing the AP-60, you should perform the following steps: • Run all wiring required for the audio and power connections for the AP-60 and projector. • If you have a projector already installed, remove the projector from the 1.5-inch mounting pipe and remove the old mounting pipe. If you aren't installing a projector with the AP-60, make sure you have a ceiling mount compatible with a 1.5-inch NPT mounting pipe installed. Parts List Before starting, make sure you have all the parts listed below. If you're missing any parts, contact Epson as described on page 26. Pendant microphone Neck strap LR6 (alkaline) AA batteries AP-60 Power cable Remote control R6 (manganese) AA batteries Lower bracket M10 bolt and nut Mounting pipe M47.5 jam nut Guy wires IR dome sensor Coaxial cable Note The included installation hardware is designed for a 1.5-inch pipe mount. You may need additional hardware if your setup varies. Additional Accessories You can purchase projectors, screens, or other accessories from an Epson authorized reseller. To find the nearest reseller, call 800-GO-EPSON (800-463-7766). Or you can purchase online at www.epsonstore.com (U.S. sales) or www.epson.ca (Canadian sales). To order an additional pendant microphone, request part number V12H3290M1. 9