Epic Fitness T20 Treadmill English Manual - Page 6
Assembly
View all Epic Fitness T20 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly can be completed using the included allen wrenches. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. 1. Slide the Right and Left Uprights (95, 97) onto the brackets near the front of the Frame (76). Make sure that the 1 Uprights are on the correct sides; the indicated holes must be facing inward. 97 Raise the Right Upright (95) until the lower hole in the front of the Upright is aligned with the upper hole in the bracket on the Frame (76). Thread an Upright Bolt (96) into the Upright and the bracket. Do not tighten the Upright Bolt yet. Holes 96 95 96 Repeat this step with the Left Upright (97). 76 2. While a second person holds the Handrail (91) near the Uprights (95, 97), feed the Wire Harness (57) in the right Handrail down into the right Upright. Pull the end of the Wire Harness out of the lower end of the right Upright. If there is a wire tie on the end of the Wire Harness, remove it. Set the Handrail on the Uprights. Finger tighten eight Handrail Bolts (99) into the Uprights (95, 97) and the Handrail (91). Do not tighten the Handrail Bolts yet. Be careful to avoid pinching the Wire Harness (57). Note: The CD Holder (86) and the Cup Holder (85) are replaceable. If these parts become dislodged from the Console Base (89), simply press them back in. 2 86 99 91 99 97 Wire 89 85 99 95 3. Connect the Wire Harness (57) in the indicated location. 3 Push all of the excess wire up into the right Upright (95). 95 Make sure that the Wire Harness is fully connected. 57 6