Edimax EW-7722UTn V2 Quick Install Guide - Page 12

Federal, Communication, Commission, Interference, Statement

Page 12 highlights

Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. Reorient or relocate the receiving antenna. 2. Increase the separation between the equipment and receiver. 3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. 4. Consult the dealer or an experienced radio technician for help. FCC Caution This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment. Federal Communications Commission (FCC) Radiation Exposure Statement This equipment complies with FCC radiation exposure set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 2.5cm (1 inch) during normal operation. Federal Communications Commission (FCC) RF Exposure Requirements SAR compliance has been established in the laptop computer(s) configurations with PCMCIA slot on the side near the center, as tested in the application for certification, and can be used in laptop computer(s) with substantially similar physical dimensions, construction, and electrical and RF characteristics. Use in other devices such as PDAs or lap pads is not authorized. This transmitter is restricted for use with the specific antenna tested in the application for certification. The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. R&TTE Compliance Statement This equipment complies with all the requirements of DIRECTIVE 1999/5/EC OF THE EUROPEAN PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication terminal equipment and the mutual recognition of their conformity (R&TTE). The R&TTE Directive repeals and replaces in the directive 98/13/EEC (Telecommunications Terminal Equipment and Satellite Earth Station Equipment) As of April 8, 2000. Safety This equipment is designed with the utmost care for the safety of those who install and use it. However, special attention must be paid to the dangers of electric shock and static electricity when working with electrical equipment. All guidelines of this and of the computer manufacture must therefore be allowed at all times to ensure the safe use of the equipment. EU Countries Intended for Use The ETSI version of this device is intended for home and office use in Austria, Belgium, Bulgaria, Cyprus, Czech, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Ireland, Italy, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Poland, Portugal, Romania, Slovakia, Slovenia, Spain, Sweden, Turkey, and United Kingdom. The ETSI version of this device is also authorized for use in EFTA member states: Iceland, Liechtenstein, Norway, and Switzerland. EU Countries Not Intended for Use None 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15

Federal
Communication
Commission
Interference
Statement
This
equipment
has
been
tested
and
found
to
comply
with
the
limits
for
a
Class
B
digital
device,
pursuant
to
Part
15
of
FCC
Rules.
These
limits
are
designed
to
provide
reasonable
protection
against
harmful
interference
in
a
residential
installation.
This
equipment
generates,
uses,
and
can
radiate
radio
frequency
energy
and,
if
not
installed
and
used
in
accordance
with
the
instructions,
may
cause
harmful
interference
to
radio
communications.
However,
there
is
no
guarantee
that
interference
will
not
occur
in
a
particular
installation.
If
this
equipment
does
cause
harmful
interference
to
radio
or
television
reception,
which
can
be
determined
by
turning
the
equipment
off
and
on,
the
user
is
encouraged
to
try
to
correct
the
interference
by
one
or
more
of
the
following
measures:
1.
Reorient
or
relocate
the
receiving
antenna.
2.
Increase
the
separation
between
the
equipment
and
receiver.
3.
Connect
the
equipment
into
an
outlet
on
a
circuit
different
from
that
to
which
the
receiver
is
connected.
4.
Consult
the
dealer
or
an
experienced
radio
technician
for
help.
FCC
Caution
This
device
and
its
antenna
must
not
be
co
-located
or
operating
in
conjunction
with
any
other
antenna
or
transmitter.
This
device
complies
with
Part
15
of
the
FCC
Rules.
Operation
is
subject
to
the
following
two
conditions:
(1)
this
device
may
not
cause
harmful
interference,
and
(2)
this
device
must
accept
any
interference
received,
including
interference
that
may
cause
undesired
operation.
Any
changes
or
modifications
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
authority
to
operate
equipment.
Federal
Communications
Commission
(FCC)
Radiation
Exposure
Statement
This
equipment
complies
with
FCC
radiation
exposure
set
forth
for
an
uncontrolled
environment.
In
order
to
avoid
the
possibility
of
exceeding
the
FCC
radio
frequency
exposure
limits,
human
proximity
to
the
antenna
shall
not
be
less
than
2.5cm
(1
inch)
during
normal
operation.
Federal
Communications
Commission
(FCC)
RF
Exposure
Requirements
SAR
compliance
has
been
established
in
the
laptop
computer(s)
configurations
with
PCMCIA
slot
on
the
side
near
the
center,
as
tested
in
the
application
for
certification,
and
can
be
used
in
laptop
computer(s)
with
substantially
similar
physical
dimensions,
construction,
and
electrical
and
RF
characteristics.
Use
in
other
devices
such
as
PDAs
or
lap
pads
is
not
authorized.
This
transmitter
is
restricted
for
use
with
the
specific
antenna
tested
in
the
application
for
certification.
The
antenna(s)
used
for
this
transmitter
must
not
be
co
-located
or
operating
in
conjunction
with
any
other
antenna
or
transmitter.
R&TTE
Compliance
Statement
This
equipment
complies
with
all
the
requirements
of
DIRECTIVE
1999/5/EC
OF
THE
EUROPEAN
PARLIAMENT
AND
THE
COUNCIL
of
March
9,
1999
on
radio
equipment
and
telecommunication
terminal
equipment
and
the
mutual
recognition
of
their
conformity
(R&TTE).
The
R&TTE
Directive
repeals
and
replaces in
the
directive
98/13/EEC
(Telecommunications
Terminal
Equipment
and
Satellite
Earth
Station
Equipment)
As
of
April
8,
2000.
Safety
This
equipment
is
designed
with
the
utmost
care
for
the
safety
of
those
who
install
and
use
it.
However,
special
attention
must
be
paid
to
the
dangers
of
electric
shock
and
static
electricity
when
working
with
electrical
equipment.
All
guidelines
of
this
and
of
the
computer
manufacture
must
therefore
be
allowed
at
all
times
to
ensure
the
safe
use
of
the
equipment.
EU
Countries
Intended
for
Use
The
ETSI
version
of
this
device
is
intended
for
home
and
office
use
in
Austria,
Belgium,
Bulgaria,
Cyprus,
Czech,
Denmark,
Estonia,
Finland,
France,
Germany,
Greece,
Hungary,
Ireland,
Italy,
Latvia,
Lithuania,
Luxembourg,
Malta,
Netherlands,
Poland,
Portugal,
Romania,
Slovakia,
Slovenia,
Spain,
Sweden,
Turkey,
and
United
Kingdom.
The
ETSI
version
of
this
device
is
also
authorized
for
use
in
EFTA
member
states:
Iceland,
Liechtenstein,
Norway,
and
Switzerland.
EU
Countries
Not
Intended
for
Use
None
11