Dell U2520D Users Guide - Page 32
Connecting the HDMI cable for U2520DR
![]() |
View all Dell U2520D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
• Use the and buttons to highlight DP. • Press and hold the button for approximately 10 seconds, and the DisplayPort configuration message appears. • Use the button to select Disable and change the settings. Repeat the above steps to change the DisplayPort format settings if necessary. Connecting the HDMI cable (for U2520DR) NOTE: The default out of factory setting is HDMI 2.0. If the monitor fails to show any content after the HDMI cable is connected, follow the procedures below to change the settings from HDMI 2.0 to HDMI 1.4: • Press any button (except the button) to activate the OSD menu. • Use the and buttons to highlight Input Source, then use the button enter the submenu. • Use the and buttons to highlight HDMI. • Press and hold the button for approximately 10 seconds, and the HDMI configuration message appears. 32 │ Setting up the monitor
![](/manual_guide/products/dell-u2520d-users-guide-0432ff7/32.png)