Dell MX9116n EMC SmartFabric OS10 User Guide Release 10.5.1 - Page 619

Path source: I - internal, a - aggregate, c - confed-external, r - redistributed n - network S - stale Origin codes: i - IGP, e - EGP, ? - incomplete Network Next Hop Metric LocPrf Weight Path *>I 1.1.1.0/24 17.1.1.2 0 0 0 i *>I 2.2.2.0/24 17.1.1.2 0 0 0 ? *>I 3.3.3.0/24 17.1.1.2 0 0 0 e AS path and next-hop The AS path is the AS list that all the prefixes that are listed in the update have passed through. The BGP speaker adds the local AS number when advertising to an EBGP neighbor. Any update that contains the AS path number 0 is valid. The next-hop is the IP address that is used to reach the advertising router: ● For EBGP neighbors, the next-hop address is the IP address of the connection between neighbors. ● For IBGP neighbors, the EBGP next-hop address is carried into the local AS. A next hop attribute sets when a BGP speaker advertises itself to another BGP speaker outside the local AS and when advertising routes within an AS. For EBGP neighbors, the next-hop address corresponding to a BGP route does not resolve if the next-hop address is not the same as the neighbor IP address. The next-hop attribute also serves as a way to direct traffic to another BGP speaker, instead of waiting for a speaker to advertise. When a next-hop BGP neighbor is unreachable, the connection to that BGP neighbor goes down after the hold-down timer expires. When you enable fast-external-fallover and if the router has learned the routes from the BGP neighbor, the BGP session terminates immediately if the next-hop becomes unreachable, without waiting for the hold-down time. Best path selection Best path selection selects the best route out of all paths available for each destination, and records each selected route in the IP routing table for traffic forwarding. Only valid routes are considered for best path selection. BGP compares all paths, in the order in which they arrive, and selects the best paths. Paths for active routes are grouped in ascending order according to their neighboring external AS number. OS10 follows deterministic MED to select different best paths from a set of paths. This may depend on the order the different best paths are received from the neighbors - MED may or may not get compared between adjacent paths. BGP best path selection is deterministic by default. The best path in each group is selected based on specific criteria-only one best path is selected at a time. If BGP receives more than one best path, it moves on to the next list of valid paths, and continues until it reaches the end of the list. When you configure the non-deterministic-med command, paths are compared in the order they arrive. OS10 follows this method to select different best paths from a set of paths, depending on the order they were received from the neighbors- MED may or may not get compared between the adjacent paths. By default, the bestpath as-path multipath-relax command is disabled. This prevents BGP from load-balancing a learned route across two or more EBGP peers. To enable load-balancing across different EBGP peers, enter the bestpath as-path multipath-relax command. If you configure the bgp bestpath as-path ignore command and the bestpath as-path multipath-relax command simultaneously, an error message displays-only enable one command at a time. Layer 3 619