Dell C9010 Modular Chassis Switch EMC Networking Command-Line Reference Guide - Page 564

tsensorAccess: ALL RUN YES NO NO NO NO usbAccess: ALL RUN YES NO NO NO NO usbPowerEnable: ALL RUN YES NO NO NO NO usbRW: ALL RUN NO YES NO NO NO usbStatus: ALL RUN YES NO NO NO NO watchdogTimer: ALL RUN NO NO NO NO YES Hardware Commands The hardware commands supported on the switch allow you to display information from a hardware sub-component or ASIC. clear control-traffic Clear control-traffic statistics from the CPU. C9000 Series Syntax Parameters clear control-traffic {all | cp-switch | linecard slot-id portset port-pipe} counters cp-switch linecard slot-id portset port-pipe all Enter the keyword cp-switch to clear the counters for control traffic on the control plane. Enter the slot ID and port pipe to clear the counters for control traffic on a specified switch line card and port set. The range of slot IDs is from 0 to 2. The range of port-pipe numbers is: 0 to 2 on line card 0 and 0 to 3 on line cards 1 and 2. Enter the keyword all to clear control-traffic statistics on the control plane and all line cards. Defaults Command Modes Example None. EXEC Privilege Dell# clear control-traffic cp-switch counters Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version Description 9.9(0.0) 9.2(1.0) 8.3.11.1 8.1.1.0 Introduced on the C9010. Introduced on the Z9500. Introduced on the Z9000. Introduced on the ES-Series. clear hardware Clear statistics from a specified hardware component. C9000 Series Syntax clear hardware {cp {cpu {data-plane | i2c statistics | sata-interface}} | cpswitch {counters} | linecard slot-id {counters | cpu {data-plane | i2c | satainterface} statistics} | hg-stats| unit unit-num {counters} | party-bus {counters} | pe pe-id stack-unit unit-number {counters | cpu | stack-port | 564 Debugging and Diagnostics