D-Link DGS-6600-48T Configuration Guide - Page 287
IPv6 Tunneling Configuration Commands, Configuration Examples
View all D-Link DGS-6600-48T manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 287 highlights
Volume 4-Layer 3 Configurations / Chapter 29-IPv6 Tunneling IPv6 Tunneling Configuration Commands IPv6 Tunneling Configuration Commands Command interface tunnel {tunnel-ID} no interface tunnel {tunnel-ID} ipv6 nd suppress-ra no ipv6 nd suppress-ra tunnel destination {IPv4-ADDRESS} no tunnel destination tunnel mode ipv6ip [6to4 | isatap] no tunnel mode tunnel source {IPv4-ADDRESS} no tunnel source Description Use the interface tunnel configuration command to add a tunnel and to enter the interface configuration mode. Use the no interface tunnel configuration command to remove a tunnel. This command is used to suppress IPv6 RA (router advertisement) on an interface of this switch. Use the no ipv6 nd suppress-ra configuration command to enable the sending of IPv6 router advertisements on an ISATAP tunnel interface. Use the tunnel destination configuration command to add the destination IPv4 address for the tunnel interface. Use the no tunnel destination configuration command to remove it. Use the tunnel mode ipv6ip configuration command to manually specify an IPv6 configured tunnel. The optional parameter 6to4 or isatap means that tunnel type is 6to4 or ISATAP. Use the no form of the command to remove the IPv6 specification. Use the tunnel source configuration command to add the source IPv4 address for the tunnel interface. Use the no tunnel source configuration command to remove it. Table 29-2 Configuration Examples IPv6 tunneling manual Configuration Example R1 and R2 are connected by IPv4 network and they are reachable each other. Establish IPv6 manual tunnel between R1 and R2 to make two IPv6 networks can communicate to each other by this tunnel. Topology Figure 29-1 Ipv6 Tunneling Manual Configuration Example Topology Configuration Prerequisites: 1. Create vlan4 and vlan6 on R1,assign an IPv4 address 1.0.0.1/8 to vlan4, assign an IPv6 address 3000::1/64 to vlan6, eth2.1 access vlan4, and eth2.3 access vlan6. DGS-6600 Configuration Guide 287