CyberPower RMCARD400 Quick Start Guide - Page 9
Using Power Device Network Utility
![]() |
View all CyberPower RMCARD400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
Using Power Device Network Utility Install the CyberPower Power Device Network Utility 2 available for download at www.CyberPower.com. 1 . After installation completes, run the "Power Device Network Utility 2". 2 . The main window of the Power Device Network Utility 2 program is shown in Figure 4. The configuration tool will display all CyberPower Remote Management devices present on the local network subnet. The "Scan" button is used to search the local network subnet again. NOTE: You can click "Scan" and select the items you want to view. Figure 4. The main window of the "Power Device Network Utility 2" program. 3 . Check the boxes to select the devices you wish to upgrade, and select "Connection" on to connect the device user account and password. Once the connection is confirmed the status icon next to the IP Address will change from grey to green. Note: You must connect to the device by entering user account and password credentials before firmware upgrade. 4 . Select the devices you wish to upgrade by checking their respective checkbox and select "Upload Firmware". NOTE: You can upload the firmware of multiple devices that use the same firmware files 7
![](/manual_guide/products/cyberpower-rmcard400-quick-start-guide-7ccf798/9.png)