Cub Cadet Challenger 400 4x4 Operation Manual - Page 7

Controls & Operation (E) (D) (J) (I) (P) (N) (A) (C) (B) (G) (G) (F) (H) (H) (O) (H) (H) (L) (K) (M) (S) 3 Seat Belt Warning Indicator (d) The seat belt warning indicator located in the instrument cluster will flash for 8 seconds once the key is turned to the ON position to remind the operator and passenger to fasten their seat belt. See Figure 3-2. Low Voltage Indicator (e) The low voltage indicator will illuminate when your battery drops to 11.6 volts. Fuel Level Indicator (f) The Fuel Level is divided into 5 segments and flashes at the lowest increment. See Figure 3-2. Gear Position Indicator (g) The gear position indicator displays the gear (P, R, N or D) that the gear selector is in. Headlight Indicator (h) The headlight indicator illuminates when the headlights are in use. Differential Lock/4WD Indicator (i) The two front wheels on the differential lock/4WD indicator highlight when the 4WD is activated. A small "X" appears between two rear tires when the differential lock is activated. 2WD 4WD (R) (R) (Q) X X Figure 3-1 Read this operator's manual, safety symbols, and operating instructions on the vehicle before operating. Compare the illustrations in this manual with your unit to familiarize yourself with the location of various controls and adjustments. Reference to the right or left hand side of unit is observed from the operating position. Save this manual for future reference. IMPORTANT: Refer to the Engine Operator's Manual before operating this vehicle to familiarize yourself with the engine controls and adjustments. The MODE (a) button switch changes the display from distance driven (KM/MILE) to time of use (Hrs.). The KM/MILE (b) button switch changes the display from KM/H to MPH. See Figure 3-2. (d) (j) (e) (h) (j) - + (i) Instrument Cluster (A) The instrument cluster is located in the middle of the dash panel. It contains multiple displays, indicator lights and mode buttons. It displays Fuel Level, Vehicle Speed (KM/H, MPH), Gear Selection (D, N, R or P) and the Odometer reading when the key is turned to the "ON" position. In addition, the Seat Belt Warning Indicator will flash for 8 seconds to remind the operator and passenger to fasten their seat belt. (f) (b) Figure 3-2 Odometer/Hour Meter (c) (g) (c) (a) The odometer/hour meter is located in the instrument cluster. To display the hour meter, press the mode button switch to change the display from distance driven to time of use. It records the elapsed time when the key is in the RUN position. See Figure 3-2. Turn Signal Indicator Lights (If Equipped) (j) The turn signal indicator lights flash when one of the turn signals is activated. The turn signal indicator lights require the installation of the trail light kit. Choke Knob (B) The choke knob is located to the right of the ignition switch on the dash. The choke is used when starting a cold engine. To set, pull out to engage, push in to disengage. 7