Compaq Evo D310v Quick Setup & Getting Started Guide - Page 20
Remove all diskettes from your system before turning it on., For example - driver
View all Compaq Evo D310v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Getting Started I Check all cable connections for loose connections or incorrect connections. I Reconfigure your computer after installing a non-Plug and Play expansion board or other option. See "Solving Hardware Installation Problems" for instructions. I Make sure that all the required device drivers have been installed. For example, if you have connected a printer, you need to install a printer driver. I Remove all diskettes from your system before turning it on. I If you have installed an operating system other than the factory-installed operating system, check to be sure that it is supported on your system. Ä CAUTION: When the computer is plugged into an AC power source, there is always voltage applied to the system board. You must disconnect the power cord from the power source before opening the computer to prevent system board or component damage. 2-8 Quick Setup & Getting Started Guide